Wireless

What are the modes available for WPS capable wireless device?

Dear sirI have one Aironet 1200 access point and I wanted to reset it password but unfortunately my IOS have found problem and it cannot work and I want to load the IOS again , according to the manual I did as follow but there is some problem would y...

So I've got a 4402, which I've configured and everything there should be good to go. I associated a new 1131AG this morning. I used DHCP to give out IP addresses, and manually input the WLC IP Address into the AP via the LWAPP command. The AP has sin...

will I be able to achieve throughput of around 100 Mbps in point to point bridge mode as 1250 series supports n draft ?

I have a Dell Inspiron 8100 with a TrueMobile 1150 PC Card. After some hunting I was able to find and install the appropriate Windows XP driver and utility program. I bought a Linksys WRT54GS wireless router, and I succeeded in getting it set up so t...

Greetings,I recently purchased a Cisco 526 Express Mobility Controller and 5 521 AP. I would like to set this all up using radius and would like to know a good way to implement with security in mind.I am having issues with getting the controller to o...

Is it possible to assign to different SSID's on an 1121AP? I would like to have both SSID's apply to the local subnet. However, one SSID would use one WEP key, while the secondary SSID would use a different WEP key. I've configured both SSID's in the...

Does anyone happen to know if the AIR-LAP1242AG-E-K9 AP (it's the AP used in Europe)is coming at the end of life?Thanks...

Good afternoon, have a customer site that has some 1240AG Access Points throughout their facility. Each one's software version is 12.3(7)JA2. Each access point is assigned a static IP# of 10.16.0.10 - 10.16.0.13. I can access each via web browser usi...

I have been setting up our new wireless environment... employee access and Guest access and folling the "deployment guide for Cisco Guest Access". I am using version 4.26 of the controller code and the Mobility achor control and data paths will come ...

I have a couple of clients that have Vista that cannot connect to Aironet 1200 APs version 12.3(8)JA2. XP works fine. I have WEP 128bit enabled also. When I disable mac filtering, all clients can connect with no problems. Also, is 12.3(8)JA2 the late...

Hi all, I am configuring wds on my access points, I have configured the master wds with priority 255, my question is I can see that there is a username and password set on each access point, what does this need to match up to on the master WDS? does ...

Hi,Does anyone know how to reset multiple AP's at the same time from within WCS 4.2? It appears that you can only reset each individual AP through the relevant GUI.Cheers,Matt

I can configure two SSID and two VLAN in the AP?