Wireless

Have a scenario where a 3rd controller is to added at a site. What pit-falls do I have to look forward to if I copy the config from an active controller to the new controller and the add it to the network. All of this assumes that before connecting t...

Im running the attached config on a AP350 access point.The AP350 gives out IP addresses via DHCP but does not connect to the internet.If I give the clients static addresses all works fine.Can anyone tell me where im going wrong.

First off, my wireless is deployed in a noisy environment (tire manufacturing).That being said, whenever I run an 802.11 MAC counters report in WCS it shows the number incrementing. I know one way to clear the counters is to reboot the APs, but that ...

I have been using my WLSE device for LEAP authentication however am in the process of retiring it as I deply more and more WLCs. Which Cisco devices can authenticate LEAP requests?I have several 4400 Wireless Lan Controllers, however not sure they ca...

Can anyone provide any info about how integrate nokia eseries phone with ccme(where download phone software, license and so on)THX...Alex

Hello,I use a WLC and Cisco radius ACS.I have two SSIDs, one for the IP phones using LEAP and one for the computers using PEAP. To authenticate on both SSIDs, I use the same username and password, only the EAP methods used is different.My problem is ...

Is it possible to setup An Aironet 1231 (Fat-AP) to work via wpa, by itself?IF so does any have any links or docs showing setup?Thanks,Pat

As the title, do you make voice in 11a and data in 11b/g? or vice versa? Thank you for sharing the experience!Zhenning

Wireless access via a Cisco Controller works well (i.e. web, mail, IM) except for IP Communicator (2.1.2.0). A protocol trace shows that the TFTP dnload occurs but appears to break when the client SKINNY register request message does not recieve a re...

Hi, I am looking for any information on structures and obstructions and how they impede and attenuate signals from a Cisco AP. I am a student and I need to put together a proposal for setting up wireless in our cinder block university. We presently h...

How I can use cautive portal in a Access Point?

Hi all, can anyone tell me how i do this so my other infrastructure access points can authenticate and register with my master access point, I have set it up in the local radius server properties but im getting this error"No Radius hosts configured o...

Hello, I am having Cisco AIR-AP1220B Series AP. It is not booting. It gives following message while booting Testing DRAM...(press <esc> to bypass)DRAM OKPower-on reset.Copyright 1996-2000 Cisco Systems, Inc.Copyright 1984-2000 Wind River Systems, Inc...