Wireless

Hello! I?ve got a Problem with Handheld Barcode Scanners that disconnect from the wlan, and then have troubles reconnecting to the (WPA - ) secured wlan. The company that make the scanners said that the option dot11 wpa handshake timeout should be in...

Hi NetPro,anyone can tell me how to resolve this ? i have check from CCO, no relevant inform. Error Message DOT11-4-CKIP_MIC_FAILURE: "CKIP MIC failure was detected on a packet (Digest 0x%x) received from %e)."Explanation CKIP MIC failure was detecte...

Hi,I have installed an access-point 1242 and for arise signal I have installed also antenna AIR-ANT2506 instead of AIR-ANT4941.Have to I modify some parameter on configuration ?best regardsLorezo

In,Cisco WLC_Config Guide_Web & CLI_Release 4.1it says,"If the TACACS+ authorization server becomes unreachable or unable to authorize, users are unable to log into the controller."Does this mean it does not support a fail-safe password like IOS does...

I have enabled PSPF on my Cisco APs and protected ports on the switch ports. Yet wireless clients can still see each other on the wireless net. Am I missing a step? Shouldn't host A (172.20.200.5) not be able to browse/ping host B (172.20.200.6)?Exam...

We have a notebook "HP Pavilion tx1000 (AMD Turion64 CPU with Vista 32bits)". The notebook is using Broadcom 802.11a/b/g chipset, running AMD and Vista. It cannot associate to WLAN using MS-PEAP and WEP-128. Also, it cannot associate to PEAP and WPA2...

Thinking about using 1250AG radios for long-haul links (10km+), but not sure they could do the job. Would a optimal solution be using lets say three 28dbi directional antennas in a 40-MHz rate at 5GHz, or would 2 antennas be enough? Trying to underst...

Is there a general recommendation for the grouping of WLCs for mobility and RF (RRM)? It seems to me that they are totally separate features. So, if I had a site with 2 mobility groups, I could technically configure all of the WLCs with the same RF G...

Has a release date been given for the new 4.2 versions of the Cisco Lightweight software for the controllers and WCS that was reported in the Webcast from yesterday?

I've got a pair of 1310 bridges running in bridge mode. I'm trying to find a way to automatically run periodic link tests and have them available for analysis. My first thought was to use kron and run the dot11 linktest and view it using syslog. But ...

I'm looking to change our LWAPP Transport from Layer 2 to Layer 3. Is is as easy as just changing the LWAPP Transport Mode setting on our controllers (4402)saving and rebooting? Will I need to reboot the access points as well? (OTAP is enabled)Thanks...

Hello! I?m trying to find out how many clients are connected to a specific AP Group (and therefor to a specific VLAN) I haven?t found any way to list me the total number of clients that are associated to a AP Groups Vlan. Is this possible?

I need to provide a 802.1x PEAP solution for a Windows 2000 SP4, Novell 4.91 SP3 client environment.Directory Service: EdirectoryRADIUS: FreeRADIUSWireless Supplicant: Cisco SecureServices Client 4.2No Active Directory user or computer accounts.We wi...

Can I track users that have B only cards and clients that have G only card within WCS reoporting. I want to turn off the B side but Management doesn't want to cut off users cold turkey with the new LWAPP depolyment.