Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

We just bought a 1242 AP's and I'm debating if I should put 1 SSID for both spectrum or different SSID for A and BG. If client has a dual band wireless adapter, will it automatically pick 5Ghz radio?

bauti1428 by • Level 4
  • 746 Views
  • 2 replies
  • 0 Helpful votes

My client has an environment where tn5250 sessions to remote AS400s are run over wireless. Their security requirements involve using 802.1x/PEAP. We would like to avoid having to have RADIUS servers at each site, but tn5250 is very sensitive to conne...

dmcconnell by • Community Member
  • 789 Views
  • 1 replies
  • 0 Helpful votes

My distributor told me i had to upgrade the memory of my Sup720's to accomodate the Wism Blade in my 6513. I can't seem to find any documentation on that.Could anyone point me to that information, or tell me my distributor is Defective Thanx in Advan...

snarf65 by • Level 2
  • 1126 Views
  • 3 replies
  • 0 Helpful votes

Hi sir; I have some problem in implement Nac on wireless lan controller. - I using ACS version 4.0 - My laptop already install CTA and Aegis secure for authentication. - Controller I have already did it. First, time I had tried to authenticate EAP-FA...

We have two old 340 bridges between two buildings that were working fine for years until last week. Now we intermittently get connection loss or high response time. I suspect inteference. On the root we have "auto" frequency which I thought would che...

gragra999 by • Community Member
  • 1029 Views
  • 3 replies
  • 0 Helpful votes

I have an environment where I have 25 Laptops connected to my wireless network using PEAP and TKIP over an XP wireless client with a certificate. I also just purchased 25 IPAQ's with built-in wireless and they have the ability to do LEAP or PEAP. I a...

d.beaver by • Level 4
  • 835 Views
  • 3 replies
  • 0 Helpful votes

Hi all,We installed 2 x Cisco 1010 AP and both of them are in the same vlan. Access_Point#1 is near (signal strength is excellent) and Access_Point#2 is far away (signal strength is fair). After my notebook associated and authenticated to the Access_...

murphychan by • Community Member
  • 935 Views
  • 3 replies
  • 0 Helpful votes

Hi there,I'm hoping that someone with experience in 802.11 can give me some help. I've just been asked to look into the fesability of replacing the wired infrastructure in one of our offices with wireless technology. The office would have approx 40 w...

Review Cisco Networking for a $25 gift card