Wireless

Hi all,I am planning to deploy point to multipoint bridges, at least 3 non-root bridges with ant-3338 directional dish antenna. Is it possible to install two directional antenna pointing in two different direction towards non-root bridges?Thanks

Hello all!I?m using the Cisco 1200 Access Points Series with two 2.2dBi dipole antennas. I have read the installation guide for that Access Points and that can be installed with the antennas in separated places. But this guide didn't mention the maxi...

Hi All,I have a small site that needs wireless access and a router. I am uncertain if I should use the 851 router with integrated wifi or go with a router and a separate 1130 access point. any suggestions on how I should choose?TIA,R

I have a working employee SSID based on IAS authentication & Active Directory certificates on a vlan. I need to create a guest SSID & a guest vlan, which I believe I can secure based on L3 access-list. Is there a way to automatically disable the gues...

I have a client wanting to do WEB Authentication using Radius with MS IAS. Initial Authentication to Web (Level 1) works fine, but when trying to modify some settings (Click Network Interfaces -> Fast Ethernet) the Login Prompt reappears stating "Lev...

I have several AIR-AP1242AG-E-K9, sw 12.3(8)JA2, configured on 5GHz as bridge with VLANs. They works fine with EAP-FAST authentication and AES ecryption, only the "show cdp neighbor" does not show the associated bridges, unless I configure "interface...

Does anyone know how much bandwidth is used per each access point/WLC LWAPP control conversation?

Hi,I have a client using Cisco access points model 1240, and Intel BG2200 wireless adapters, and during the day the laptops working on the wireless network lose it's connection and then reconnect again several times by day. I've seen some posts about...

Hi,I tried to configure eap-tls from this link :http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_white_paper09186a008009256b.shtml#wp39392Certificate configurations on csacs and the client sides seem to be OK, but the XP client is flapp...

Hi,1) Does anyone have experience with this procedure that they would be so kind as to share?Is it easy? difficult?Any glitches?I have read the first few pages of the procedure.2) Are there any differences between the AP you end up with after the con...

Anyone with problems with the intel PRO/Wireless 2200 BG card (driver 9.0.4.13 (latest)) in combination with IOS 12.3.8 on the AP's ? I had no problems with our old ios 12.2.15, but since we had the upgrade to 12.3.8 I have serious connection problem...

Hi,We want to do AP Group VLANs.Described at,http://www.cisco.com/univercd/cc/td/doc/product/wireless/hahcont/wlansc.htm#wp1040568It's quite clear how to do this in WLC Web GUI but I can't find any reference to it in WCS docs.Can WCS create AP Groups...

Hi,we are using 4 WiSM with 8 wlc and software version 3.2.116.21. We deployed about 550 Lightweight AP's Aironet 1131. After a few weeks, the wlc stops logging messages to the syslog-server. Also the webinterface is affected. It restarts logging to ...

We are planning to upgrade our wireless network by replacing all our 350 bridges with 1300's. However this wont happen for all our sites and we are thinking of replacing all our root bridges with 1300's and will replace the 350 bridges later. I have ...