Hello all,I have tried following the instructions provided on the TAC site to reset the AP to default settings, but this procedure doesn't seem to work. The AP has a firmware = 11.17 When I tried to enter the :resetall command specified in the sup...
Hi,I would like to know if the 1200 series 802.11a client Adapter supports Pocket PC. Are there plans to develop drivers for the WinCE platform ?Also are drivers for Linux curently available for the Cisco 802.11a cards. Anybody working on developing ...
Hi everyone,Someone told me about this issue this week. I heard that roaming between APs was not possible without reauthenticating when RADIUS authentication is used. This means that you need to reauthenticate yourself to the RADIUS server each time ...
Win 98 PC with 350 PCI card, 4.25 firmware, 8.2.3 drivers, ACU 5.02.005. Attempting to use LEAP with saved username and passwordagainst the local database on ACS 2.6 via AP340 11.10T 802.x draft 10. The PC boots, username and password for NT domain s...
Looking for a good commercial (not homemade) solution to reflect signals around obstructions. I do not have point to point line of sight, but have a third location that does have LOS to each site.Planning to use BR350s at each site.Thank you.
Hello,I´d like to roll out an WLAN Netwwork with 4 1200 AP / 1 x W2K Server / 18 x XP PRO. The security with WEP encryption is to weak. So I´m looking for a solution. Can I get high security with only W2K and XP Pro or do I need the Cisco Secure AC...
I have 3 repeaters connected to 1 AP ( as root). All unit are using same SSID, different radio channels. Other settings are default.However, all repeaters are intermittently associated & disassociated with the parent AP, at least every 2 minute. What...
I used this link to help me configure the ACS and the Cisco 350 Access Point.http://www.cisco.com/warp/public/cc/pd/witc/ao1200ap/prodlit/wrsec_an.htmAll I want to do is to only allow certain MAC address to associate with the Access Point. No LEAP o...
Hi all,i have a big problem.well, i have 3 cisco aironet 350 series and i lost password.how to recovery my password ??? the version of used software in these bridges is Aironet BR500E V8.24please, help me !!!!!tks...
I noticed that there are two differnt types of workgroup bridges. They are:AIR-WGB352C: One nonremovable 2.2-dBi dipole antenna included AIR-WGB352R: Two RP-TNC connectors (antennas optional, none supplied with unit) What type of application would de...
Cannot even connect via hyperterminal with required settings. Plugging in with ethernet doesn't do anything either except I get a blinking light on the switch. Never any light on the device.
I have been running couple of 350 bridges for about a year now. My firmware is at 11.23T. I am looking for information, hopefully a step by step, to enable the highest level of encryption / security that I can.I am running these in bridge mode betw...
