Wireless

I have the Aironet 350 wireless lan adapter and i can't get it to work with my laptop with Windows ME. I downloaded the Aironet Client Utility software from the Cisco website and installed it. The laptop recognized the lan adapter but when goto the A...

I have installed a PCM350 card into my NEClaptop running MS-DOS operating system v.6.22.When the driver starts up, shows the followingmessage:Card services not present, trying 82365.Driver resources ---> IO Ports: 0300-033fIRQ: 0B Memory: D000Radio c...

Hi,i'v got ap 1120 with cisco client 350 and intel cetrino client'swhy i can't see under assoiciation the device type and name?i use the latest ios version on my ap's.thanks in advanceAmi

I am trying to setup my AP to act as a dhcp server and having problem..Originally all wireless clients get their IP address from the Microsoft dhcp server, once they successfully authenticate with cisco ACS.I have setup the following on the AP but th...

I trying to configure a new wireless adapter (802.11a/b/g Carbus Adapter) but went i install the driver i receive the fallowing messagen from the client "Client Cannot Access Wireless LAN Adapter" if anyone resolve that problem please help me, thanks...

I have a RADIUS sever with Cisco Secure ACS 3.1 and I am trying to setup non-Cisco clients to talk to the server for authentication. Basically they are built in wireless IBM client cards (Prism) using NIC firmware 1.03.03.00. These cards support 128 ...

Is there any known configuration to configure aaa authentication for wireless Access points, in the manner "aaa authentication ppp" is used for dial-in customers; or can that command work with wireless APs??

I want to setup HOT SPOT with Cisco So Can I use 350 bridge as an Access Point with 12dbi Omni directional antenna? can we configure ETSI based bridge to 100 mW power?

Can any confirm that SSH or AAA NEW-MODEL doesn't work with Aironet IOS?I checked the aironet command reference and can't find anything...

I purchased a Dlink DWL-G800AP Wireless 802.11G repeater as a low cost portable solution to extend the range of our Cisco 1200 Series Access Points (802.11G versions). The Repeater is able to see our Cisco 1200 AP without issues, but it just doesn't ...

i have cisco bridge 250 working in root mode. On station details and association table some IP addresses of the associated station look like IP Address ?10.3.2.19 What "?" means ?

Hello all,I currently have a Wireless LAN implemented in one of my buildings using Cisco 350 Client adapters and AP's. I have a user that is about three blocks away from the nearest AP and I was wondering if anyone had any ideas on how I can make/buy...

I just want to know whats the effect of using a splitter on aironet 350 right/primary port....will the signal decrease and by how many db?.thinking of using patch 14db antenna on both point...appreciate help on this...

What is the diff b/w VALNs created in a access point and that in a switch where an access point is terminated? which one is better

Does any one have a problem with Toshiba portege R100 on connecting to WL Cisco AP-350 it is associated with the AP but does not get IP address, after a few play with network configuration it work ok but next time of reboot the same problem again, al...