Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
We have a WLC 5520 that suffered a power loss on Friday. Since then the unit has been inaccisble via its standard IP Address. Upon gaining console access to the device it appears to be idling at the Configuration Wizard/Autoinstall. Here are the Erro...
So if I statically assign DFS-required channels on my APs, what happens when radar is detected on that channel? Will the AP just stop transmitting? I haven’t been able to find any real information on this. Thanks
Hey Guys, I'm running a pair of 9800-40 WLCs in HA SSO mode (with RMI) that are directly connected to the upstream L3 switches that handles the DF GW for the WMI subnet. Due to the geographical location of the server room i had to connect the RP to t...
Does Meraki devices still provide PSK authentication for some of the old devices to be mapped on the existing SSID?If not what could be a possible solution?
Greetings All, Approaching your support and assistance as we have regional WLC and we have multiple sites working fine except one site locate in India, users were facing an issue "Not able to connect to corporate WIFI SSID or connecting after long ti...
I'm setting up a lab to do some research on the C9130AXI-B wireless access point. As I understand it, I cannot do anything with the AP without a wireless controller, so I'm now trying to install that.I've downloaded C9800-CL-universalk9.17.09.03.iso...
Hi,I am having an issue with AVC statistics on a foreign anchor setup using 9800 controllers.Anchor is on 17.3.6Foreign is on 17.9.3No data on the anchor for any of the clients connected via the foreign. Clients connected directly still show data.I f...
I went inside ROMMON moved Access Point 1852i to part1 and part2 but my device still can't access the inside.I did a hardware reset but it didn't workDisplay messageNo valid user found, please configure a valid user from Controller% Authentication fa...
I am performing a migration from an old WLC 5500 to a new WLC 9800. After migrating all accesspoints in one building, all iPads started to have problems with finding airplay monitors , even though they are on the same vlan/wlan.Any Ideas?
Hi Team,Can someone share me the procedure for 4010 IE model IOS upgrade. I am using the tar file for upgrade.Thanks a lot in advance.
Hello All,I have two AIR-AP3802I-E-K9 aps that are refusing to change to the correct WLC. When I check the regulatory domain setting on the wrong WLC for the two APs its selecting a different region and the region for the WLC they should be connecti...
Hello, I would like to know, how many client can connect to Cisco 9115AXI AP at the same time? Or how can I select the AP base on user? Thank you.
Hi all,I've got a Cisco 9800-40 WLC with software 17.6.5I've also got a WLC 5520 with software 8.10.151If I try to move a 9210 from the 9800 to the 5520 the AP doesn't move, even after I change the controller on the HA tab and reload the AP.Although ...
I need assistance in installing the above access point. I'm a beginner and don't know where to start . any assistance will be greatly appreciated.
Hello,I am using a Cisco WLC 9800 with software version 17.9.3. My access points are 2700's and 3800's and are in local mode. I implemented a consent page with LWA around two months ago. For the first month and a half, except for a few rare issues, w...
