Hey Community! I'm excited to share something we've been working on that I think will really resonate with many of you managing wireless networks today. We just released the Cisco State of Wireless Report 2026, based on insights from over 6,000 wirel...
Forum Posts
Resolved! NPS Authentication and WPA3
I'm setting up a new Wi-Fi network with RADIUS authentication. It will have 20 Meraki CW9166I APs installed on an existing Cisco switch network, with known good DHCP and DNS services. There is already an NPS in place, and having entered the NPS addre...
Hello I have a cisco 2500 series wireless controller with two AIR-CAP1702I-E-K9 antennas.Here is my problem when I connect to wifi everything works I can access the internet from my phone or laptop. But on the other hand I don't see any computer or p...
Resolved! AP Tag via API
Hi guys, I have a question.Is it possible to create a tag via API and add specific APs to this tag?Unfortunately I have not found any information about this on the net.Thanks.
Radius auth stopped working with "failed to connect to the RADIUS server."Ping works, Radius servers works fine with all other wireless networksand it seems from packet capture it don't even try to send anything and immediately fails.We have 3 MX67W ...
Hi everyone, First of all it's my first post in the forum and i don't know if i post on the right place, moreover english isn't my mother tongue and i apologize in advance for any language errors. To expose my problem : I have client with an embedded...
Resolved! Mixed Mode SSID
I'm trying to reduce the number of SSIDs that our company utilises. We are in the process of deploying a new ISE service, and so we should be able to combine 4 SSIDs into one, by getting ISE to assign the relevant local VLAN that clients should break...
Hi All, one of my Customers had the Ideas to deploy IW9167 with up to 4 external Antennas and to realize a multiple Cell Design,see attached drawing. Is that officially supported? Regards, Mike
Hi everybody. I have recently joined an IT company where Meraki system is already available but I am new to use the Meraki devices except basic fundamentals which I have learned through various tutorials and videos.I am facing below mentioned challen...
Hello Experts, Is this possible to enable active directory authentication in CBW 240-AC access points? If yes, please share any document to configure the same. Thanks in advance. Vikas.
Hello,I'm setting up a Catalyst 9800CL WLC and I have it working as needed with 2 SSIDs. I'm adding a 3rd SSID just as I did the others along with a new VLAN (no SVIs on the 9800 as my ASA firewall is acting as the gateway and DHCP relay server for ...
Hi All, Going through the SDA-fabric SSID creation on DNA-C (Latest release), I am trying to configure "Guest Access with Sponsored Guest" and the only options available in DNA-C are self-registration and hotspot portals????. I know self-registration...
Hello,I want to open the settings -> wireless & network directory from my application. But I don't know the how to do? Please help how can I do? Any help will be appreciated. Thanks in advance. MyAccountAccess Credit Card
Resolved! 8540 WLC Set up
HiI have a new 8540 WLC to setup so when i boot and it loads up I say no to autoinstall and then go through the steps, why does one of the steps ask me to add an SSID name ? should the name I add be an SSID that I will be later broadcasting ? also i ...
I would like to block all MAC addresses (can also use host name) except those that are whitelisted on an SSID
Resolved! FIREWALL LAYER 7 MR-44
The Access Point MR-44 can block users by the type of Operating system such as Android, Windows, Mac?
