Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
Hi there,Here's a little background for context: I work in K-12 where I have a high school with around 3000 students and about 175 staff. We are a 1 to 1 district where students get Macbook Airs and staff gets Pros (and several shared laptops, deskto...
Hi Please see the below diagram with central dhcp server. Not sure how to define the "central". When we create dynamic interface at wlc, we need to enter dhcp server ip address. Can we say this dhcp server is central dhcp server? otherwise is local d...
Hello Experts , for one of my sites, i had to de-commission the local and had the ap's flexconnected to a regional wlc which is a 9800.the ap's are 2800I and using flexconnect local switching now once the change was done, user started complaining low...
Hello, i changed my wifi setup from Unifi to Cisco and make my first steps.In syslog i cab see many entries like the following messages%RRM-3-RRM_LOGMSG: rrmLrad.c:5634 RRM LOG: Failed to lookup data rate for encoding 35389926, with channel width 20 ...
Hello there, I added an AP Group on a WLC Cisco 5508 but this AP Group does not appear in Prime 3.9.0.In Prime there is an issue "Wrong CLI Credentials" does this correspond to the missing synchronization mentioned above?Also the associated APs which...
I have AIR-CAP2802I-E-K9 AP and it was working fine, suddenly it was disassociated with WLC, I found its static IP configuration was washed out, I tried to prime it through console and on that time it was associated with controller, as i powered off ...
Dear all, anyone has any recommendation what are the requirements from Catalyst 9800 (IOS-XE 17.3.3) configuration point of view (Flex Profile, Policy profile,...) in case you have an AP which suppose to broadcast locally switched WLAN, however on lo...
WLC Cisco IOS XE Software, Version 17.06.01C9800 Software (C9800_IOSXE-K9), Version 17.6.1, RELEASE SOFTWARE (fc6)AP ver 17.6.1.13 My 1+5T phone (Snapdragon 835, Android 10, Security patch 2020.09) won't connect to SSID.I've tried configurations like...
Trying to convert 1572E from lightweight to autonomous but not working. Configured and IP in ethernet port and bvi interface. APac3a.6744.a720#ping 10.1.1.1Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 10.1.1.1, timeout is 2 seconds...
Greetings, The 9120 AP needs to have the CA certificate as trusted certificate so that it can connect to the RADIUS server and authenticate as Dot1x supplicant. Could you advise how to upload the CA certificate to the AP ?. The WLC is a 9800. Regard...
Hello community, I have an issue with cisco WLC 9800, for wireless users I have 50 vlans, the issue is that when I want to create a Flexprofile it's only support 16 Vlans, there's any solution for this issue. Wireless LAN Controller
Hi really hope that someone can help me. I have a WLC running 8.5.171.0 and it has 3 x LWAPP 2602's connected to it. All three are seen and connected to the WLC. 2 are in one location and 1 in another. All three have their correct IP's, and I can...
What is the stable 9800 WLC Release ?TAC recommended 17.3.4 with APSPs and SMUs causes 9130 APs crashing 20 times a day.
Hi Please see the below session of cisco document and its link. What vlan does the AAA server provide with highlighted "VLAN provided by the AAA server"? The vlan is referring to the same vlan that is configured as native vlan at the switch port? Tha...
Hi For local authentication with Flexconnect, is there any difference between authentication at the AP and at local radius server? Thank you.
