Hi,
Does IOS-XR minor upgrade from 5.3.1 to 5.3.3 on ASR9922 impact EEM and VRF license ?
Are there any issues for this ?
Also, rolling back from 5.3.3 to 5.3.1 impact anything like config, EEM,l icense etc ?
Regards.
Hi,
Does IOS-XR minor upgrade from 5.3.1 to 5.3.3 on ASR9922 impact EEM and VRF license ?
Are there any issues for this ?
Also, rolling back from 5.3.3 to 5.3.1 impact anything like config, EEM,l icense etc ?
Regards.
Hi,
Does IOS-XR minor upgrade from 5.3.1 to 5.3.3 on ASR9922 impact EEM and VRF license ?
Are there any issues for this ?
Also, rolling back from 5.3.3 to 5.3.1 impact anything like config, EEM,l icense etc ?
Regards.
I'm surprised at how many knobs I don't see for configuring the ATM interface on my 9k. Perhaps this bodes ill for my effort.
I am not getting ILMI to come-up, and odd errors related to AAL5 padding length. Here are some outputs:
show atm int atm...
Hello,
I have ISIS neighborship between ASR 9k and Nexus 9k.
I can see routes for ipv4 address family being installed and shared between both routers.
For ipv6 routes are being installed in ASR but I don't see any ipv6 ISIS routes in Nexus 9k.
An...
Both 9Ks are on 5.3.4. I have a single NV SAT that sits between the two 9K's
Is this the expected behavior of Router 9001_B to be in Cold Standby? Thanks
****************************************** 9001 A config ***********************************...
Hello All,
Is it possible to run the "A99-12x100GE-CM" on ASR 9010, I know that it is meant for A99K Chassis hence the name A99-12x100GE-CM, still am just wondering if it is possible or not? even if it meant getting like only 8 x 100G out of it, sin...
Hi all
I have a running ASR9K (9006) and another ASR9K (9010) , what am thinking of is to migrate the existing ASR9K 9006 to the ASR9K 9010
They are running RSPs and different LCs , is it possible for me to do it ?
RP/0/RSP0/CPU0:ASR9010#admin show ...
Hi
Noticed today that you have done some syntax changes between 5.2.4 and 5.3.4 when it comes to dhcp ipv4 snooping.
In 5.2.4
Dhcp ipv4interface [GigabitEthernetX/X/X/X.xxxx snoop information option format-type circuit-id test123
In 5.3.4 this se...
I hope this feature will be released soon! We have many ASR901 for traffic aggregation of customer PPPoE connections. Requests come from EoMPLS circuits to ASR9K routers through subinterfaces.
So I need to use subinterfaces (ASR9K with 6.0.2) and thi...
Hello all. Without having to go through tons of documentation (which I will at some point), i'm just trying to figure out what this command does when put on an interface? For example, I notice I could apply a service policy directly under the inter...
Hi there
I need to failover to our standby RSP-4G on our 9k due to cisco wanting to RMA our current Active RSP.
Is it a hitless operation when I do a switchover? so no impact / loss of traffic?
Once the RSP has been switched over, I can eject the ex...
