IP Telephony and Phones

hi there,I have a project where I would like to do some recording with CUCM and another third party solution : Calabrio.I saw the procedure on how to do that ( Rec profile, sip trunk, configure services, privacy off , built in bridge on , automatic r...

Hello,We are currently in a rollout of ~200 locations in which we are deploying 2921's with EVM-HD-8FXS/DID, EVM-HDA-8FXS/DID, and PVDM3-64 we are running IOS 15.1(2)T3,. The 2921 interconnects our KSU, modems, faxes from a SIP trunk provided by our ...

We have  3560-24PS on site already configured with a VoIP vlan.We wish to add  Minicom 6000, 6000P and 7000 series made by Teletec International.http://www.connevans.com/instructions/40tm6000.pdfHas any one had any expereince adding these to ATA or a...

Not sure if I bricked this.  We used to use Asterisk so my 7960 phones and 1 7970 are flashed to SIP.  All works fine.  I tried to flash the 7970 back to SCCP but I think I screwed up the phone big time.  I wanted to flash them before I received my U...

HI AllIf i want to add New extension range on call Manager so should i only creat partition and CSS for that OR i have to add that extension range anywhere else.Example :We have existing extension range from 501 --> 599 and now i want to add new exte...

Hey Guys.There are 2 T1 lines configured, and one of them went down. I ran the "sh isdn status" cmd in VG, one of them shows for Layer 2 "TEI_Assigned and the other one is up which shows as "Multiple Frame Established".. and one of the Controllers is...

Having a CM 8.0 system up and running, if i want to add a new 8945 ip phone, what licensing i must purchase??Any help please.

AN issue with CME, the conference bridge is not registering after a recent configuration change..Here is the running-config (only revelant config) [IP ADDRESSES HIDDEN and INTERFACES HIDDEN] from the router..voice-card 0 dspfarm dsp services dspfar...

Hi Expert,I want to customize open greetings to replace the system default like "Hello, cisco unity conntion system....", i recorded my greeting in system call handlers-->open greeting--->EDIT->Greetings-->Standard, and check the option which Caller ...

I have cisco CME V7.0 in Main office and it's using FXO to connect to PSTN, I have other PSTN lines in another building that i want to use as well.I have another CME with FXO readywhat I want is the following:I want to connect the main CME to other P...