Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hello,I have performed a factory reset of a 7942 running 903 firmware.However upon boot it now hangs on upgrading and does not seem to do anythingI have checked that the term42.default.loads and all its references files are on the tftp serverDHCP is ...
guyshave a strange issue with phone licensing unless im reading the documentation incorrectly.i have 6921 phones that are stated to have 3 DUL. however, on my CUCMBE 7.1.5 im seeing the phone taking 4 DUL per phone. can anyone assist in an explanatio...
I am trying to assign extension mobility and the Corporate Directory to SURL buttons on a Cisco 7975 Phone. These Services are not displayed under Subscribe/ Unsubcribe services for the Device Profile. Therefore unavailable to assign on SURL buttons...
Guys,just doing some labs here on the new MeetingPlace app. Im no guru by any means but im missing something basic and just wanted to clear up. Basically, i have the lab, registered for the demo licenses and everything is installed. Ive installed Mee...
Hey,We have a CISCO CUBE and a Dialogic Gateway both connected to 2 different mediation servers.PSTN Calls through Dialogic can be placed on hold.PSTN calls through CUBE fail with error message "Call cannot be placed on hold. Your speaker and microp...
I have users with 7925's and CUCM 6.1. The supervisors are asking that I limit the ring tone chices. Is there a way to limit this without limiting all phones?Thanks,Wes
Hello,I'm having trouble splitting voip traffic from the data traffic. I am using a 5505 asa and 3560 switchesASA 5505 > catalyst 3560 > IP phone > laptopon the ASA 5505------------------------I configured 4 Vlan's1 for management1 for outsideinterf...
The following is the topology.CCM servers,V5 centralized deployment. Around 30 sites are using this call managers over WAN. More than 3000 phones are there.Problems:*Phones were started to resetting and the phones are stable after few reset.*But the ...
Hi,I have configured 7942 phones with VPN certificate based authentication803 CUCM, 903 firmware and ASA 8.4Everything works fine, except auto network detection.for some reason when I plug phone into corporate network it thinks it should run VPN clie...
We are planning a CER implementation. The documentation states that we need at least one DID for each ERL. However, management thinks it is a short-coming of the CER system if it forces such a requirement. I explained to them about how call-back ne...
I cannot initiate a video call with a 9951. The 9951 can display video if the remote side such as a CUPC soft phone initiates a video call but there is no soft key or programmable feature button to initiate a video call. I have loaded 9.0.3 sip-9951 ...
Client with 7825H 3.0 servers. These servers appear to come with a RAID controller (Broadcom|CSB6 RAID/IDE Controller), but have only one drive. Anyone know if it's possible to add a drive for RAID1, and if UCM6.x/7.x can support it?Thanks in advance...
I have a CallManager 7.X running on the Cisco MCS-7845 platform. My question is how many internal conferences are supported with this platform?
Hello!I am about to make an IP telephony installation (CUCM 7.0) with 3 telecom providers as gateways to PSTN.Two of them will be connected to one Cisco router (2911) where I will install CUBE (IP to IP gateway). My side will have H.323 signaling, wh...
Hi all,Does anyboby have any document on the pros and cons between SIP and PRI ?I understand PRI has been around forever and SIP is a fairly new technololgy and it seems like that's where everybody is headed. What are the extra benefits with SIP ?Tha...
