IP Telephony and Phones

I am running CUCM 6.1.1, and am trying to upgrade to 6.1.3. I have a pub and two subs.I did a switch version on the pub, but when I went to login to CLI or Web, I noticed that my password had reverted to my previous password. This made me suspicous...

Hi All -I am running Call Manager 4.1(3) and Unity Connection 1.2(1) and have 24 VM ports. Three of the 24 ports (port 6, 14, 19) have a status of "NOT FOUND". No matter what I do I can't get them to register. I have tried resetting the ports in both...

Hi allI am constantly having to restart the IIS service on the server as the web admin page hangs when trying to log back after being either unused or even when just being fired up and entering login details. I have checked the bugtoolkit and cannot ...

Error with RTMT after upgrading to CUCM 7.1.2aWhen I log into RTMT I receive an error that RISDC is down or unreachable on both servers in my cluster. I have checked that all services are running from CUCM servicability pages.Could this be a bug?

Hi ,i am facing problem with call forwarding , i set Call forward all to my mobile but the calls come from PSTN aren't frowarded to the mobile and faild, but the incoming internal calls are forwarded to the mobile.details:CCM version is :6.1gateway ...

I am trying to setup a translation-rule for all international calls (011) so that the type is changed to unknown. I need this to interface properly with my telco.I've created the translation-rule fine as verified by the test command, but getting it ...

We have 4 digit dialing setup in our organization for calls within the organization. It just got me curious Where and how do I need to set up if I were to do a 3 digit dialing?Any suggestions to help me answer this question will be greatly appreciate...

I mean, forexample I did some bad select with AXL Toolkit,that could impact the virtual memory of CUCM. How I can stop this select in AXL?Thank you

Hi list,Is there a way, any service parameter etc tuning inside CCM which can give my callers to hear the call-waiting tone while the IP Phone still sees the incoming call indication on phone. This is when Busy trigger is set to 2 and there is alread...

Hi,I would like to know whether I can configure UC520 as h323 gateway for CallManager and at the same time I install CME on it ?If possible, how is the connection betwen CUCM and CME ?Thanks

My site in Germany needs to be able to select missed calls and have a 00 added to the front of the number so that they can redial the call without having to enter digits. Is this possible?

What's the main difference between Client Matter Codes and Force Authorization Code ?

Hi,Is it possible to make a trunk connection between two call manager and make a line between them. So if we can make a trunk does these phones make rtp between each other with their own ip address' or via call manager ip address?thanks

Hi, By mistake i have deleted the firmware of a cisco ip phone 7941 uing this code # 3491672850*#its connected to call manager version 5.1.3.2 now all it shows is a blank screen.Is there any way that i can load the Default firmware to this phone with...