I have a CallManager 4.0 and I'm trying to register some 7941 phones with it. I installed the Device Package and the Device load for 7945 but I still cannot find the 7941 as an option in the devices.
We are looking to monitor pstn trunk utilization from the Cisco Call manager 5.1.Can someone please recommed a MIB that specifically gives us this information.
Hello,I have a CCM 3.3Two 7905 IP phones registred in the same partition.And if I try to call from one to another it shows the error message : 'number not available'What can be the problem due of ?Regrads,Omar
Hi,We have a setup with two Cisco routers connected to two E1 R2 circuits (one per each one). Gateway is H323 controlled.Call Manager is 4.1(3).I have a Route Group for each one of the E1s and those Route Groups are in a Route List, which in turn is ...
Hi,I have CUCM 6.0 running in the network, Cu has remote site where we required BACD should runnI have 2811 router with 12.4 15T IOSI need a running config of BACD script.Consider my dial in number is 8 digit Please post guys i need it urgently.I hav...
Hi,I have a CME router connecting to the gatekeeper and i have made a trunk from CCM to gatekeeper Config :-CMEdial-peer voice 1 voip destination-pattern [1-2]...$ voice-class codec 1 session target ras tech-prefix 1gatekeepershow gatekeeper endpoint...
Hi list,I have tried configuring VPIM networking between Cisco Unity and CUE couple of times however it never seems to work. Can anybody explain the proper procedure to configure the same. You can refer to following scenario,CUE ID - 200Unity ID - 10...
Hi i am facing a problem with the ccm 4.0 telephone directory when i clcik the directory it prompt for the username , password and realm instead of missed calls recived calls and placed number.for voice messaging we are using Unity too.please help ...
Hi All, I am using CUCM 7.0, MGCP with PRI. when incoming call doesn't have caller ID or number as anonymous call, the call is failed. I've setup PRI as national numbering plan on both gateway serial interface and MGCP endpoint in CUCM. Call with num...
Hi,I'm facing the following problem. I have router in SRST mode and I want to reach the Cisco Unity through PSTN (R2 Digital without ANI). I have tried the vm-integration but it doesn't work. Also tried to prefix in dial-peer with pauses ",,,," but s...
Does anyone know if Vista is compatible with Cisco Unified CallManager Attendant Console 1.4? The datasheet just lists Windows 2000/XP. Are there any known issues or minimum Vista service packs?TIA!
CM4.2.3I am setting up a site where the pstn gateway is located in a data center physically separate from the actual users. My problem is when the end user calls 911 it will show the location of the data center not the office location where the user ...
i'd like to setup a lab that consist of call manager and unity (at least ver 5), a switch /w poe, and couple of cisco ip phones (7961). is there an evaluation version of call manager and unity that can run on vmware? if so..how can i get a copy?
