IP Telephony and Phones

we have callmanager 6.1 with mobile connect currently when i try to hand off from my cell to my desk phone it gives a fast busythis only occurs with at&t... all other providers work has anyone see this issue

Hey All - I am in the midst of a UC 6.1 upgrade that has been a bit of a challenge. However, I was asked by the customer today to make an additional change that I am a little stumped about: They have an existing CallManager 3.3.3 2-server cluster, ...

hi, i tried to configure "fac custom park" in CME 4.2. i found the function can't work properly. But fac custom pickup and callforward are fine. does anyone try it before ?best regards.fred.

Hey all..We are running a new install of 6.1.1.2000-3 that is having intermittent issues placing callers on hold.Situation:- user is on the phone with caller #1- Phone rings with caller #2- user presses ANSWER to talk to caller #2> Caller #1 does not...

Hi there,I have a customer running 5.0(3). They have a subscriber they never activated.We are trying to load 5.0(3) on the subscriber so we can eventually upgrade to a 6.xThey don't remember the Security password for the call manager box. So during...

CCM 4.2(3)I recieved a new .mp3 file for our MOH. I dropped it in the 'drop here' folder, the conversion completed fine, I added the source to the MOH server okay, but when I change my phone to the new stream (both device and line), nothing plays wh...

We purchased cisco reccommended servers for a new 6.0, configured the arrays as instructed but can't seem to figure out a way to cinfigure the nics in a team. The servers are HP DL380 G5

I installed a VG248 in our server room. I am experiencing a large amount of line noise on all 48 ports. It is so bad that the modems I have plugged into it are not working. I have many other VG248's throughout the facility and they do not suffer f...

I currently have CCM6.1 setup in a lab using VMWARE. I have 2 phones setup and registered to Call Manager. I have 1 CSS and 1 Partition. Both phones are part of the CSS. The phone DN's are 5001 and 5002 and are assigned to the same partition. When I ...

I added a subscriber server to my cluster and my database stopped replication. I tried to use DBL helper but the program would not connect to the database at all. I then reestablished the subscriptions manually in SQL.Everything seems to be replica...