IP Telephony and Phones

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...

call forwarding.png
Translator by Community Manager
  • 6103 Views
  • 14 replies
  • 0 Helpful votes

Hello;I've installed a UC500 with CCA 1.6 and two 7960s. I've used the CSA Software Upgrade for the UC500. However, the phones were deployed with MGCP before and show up on the topology as such. How can I upgrade/change the 7960 phones' f/w (which I'...

amir by Level 1
  • 552 Views
  • 1 replies
  • 0 Helpful votes

I am running CM version 4.1-3I am trying to replace hardware and do a BARS restore. I restored the new publiser off line and just connected it to the network (which i have done many times before) but this time I noticed the two subscribers would not ...

Hello All,A quick voice gateway design question. I have a 2811 currently acting as a WAN router for two remote sites. I have a 3750 switch stack, which is doing routing for my main site VLANS (about 10 vlans). Right now I have a routed link betwee...

wrkemmer by Level 1
  • 352 Views
  • 2 replies
  • 0 Helpful votes

I have an issue trying to determine the best way to route inbound calls into our organization. This boils back to the age old problem of regular Hunt Pilots vs. Attendant Console Pilot Points.The situation is I have operations staff that are respons...

telcorinc by Level 1
  • 495 Views
  • 2 replies
  • 0 Helpful votes