IP Telephony and Phones

Here is my situtation - Brand new 9.1.x cluster.  LDAP was not ready, so local users we configured so that I could import the phones.  In previous versions of CUCM, once LDAP intergation was enabled, the existing local users would be replaced by the ...

We have simple cisco jtapi application, the primary use of this application is to capture all event from CUCM (Call Answer, Call initiate, call hold, call resume, call transfer, call conf). We are able to achieve call Answer and Call Initiate by usin...

I have a client that is looking to allow internal users to call Locally and Toll-Free.  Unfortunately, the CORs available do no allow that without opening full long distance calling.     Internal—Privileges to call numbers that are internal to the o...

I have been unsuccessful with adding a custom image to the 8841 VOIP phone. I cannot seem to find/create the list.xml file. I have sshed into the CUCM but first insured the TFTP services were started. CUCM version 10.5. I also created a new Common ph...

Hi. I have a problem: I can't open CUCM sdl files after few hours the maximum is 1-2 hour, I think they are getting overwritten by new sdl files... Also same thing with alerts-few hours and nothing.  Is it disk space problem or some setting on CUCM ?...

Hi Team,      one of our customer requires their cucm  (BE6S platform) to integrate with a hosted PBX. the hosted PBX supports SIP trunk and they will provide the server address, username and password for the SIP trunk.       Please advise  on the re...

 Hi Experts,   I want to upgrade one ip phone 7962 registered in cucm 11.5. I have done following steps.   Phone Load Name: SCCP42.9-4-2SR1-1S Load Server: IP address of one voice gateway   This gateway is acting as tftp server. files are in flash fi...

I am currently using ISR4331 to setup a voice gateway with the image version of Cisco IOS XE Software, Everest-version 16.06.02. The error was appeared when the user try to making call using their IP telephony. I had tried to do some research and fou...

Our organisation is currently in the process of rolling out Skype for Business and are also trialling single number reach to ring the Skype client simultaneously whenever a users desk phone is called. Our current setup is below: Users primary ext: 6X...

Dear All,I am relatively new to the world of Voice but I am learning quickly. In my current position I have 3 CCME routers. Two of them are working fine. However, the third machine does not allow me to do any configuration via the GUI. The page displ...