Network Management

Hi, I want to monitor router RV042 using SNMP, the problem is that I cannot find MIB OID to monitor status of each LAN port (4 ports) and each WAN port (2 ports).I use RFC1213-MIB, but the router can only provide status of 3 interfaces and all of the...

Hi Guys,I setup one network where LMS is in subnet 192.168.5.0/24 and CUCM is in subnet 192.168.1.0/24. both are reachabe to each other and  both are also in different EVN/VRF. when i try to discover the CUCM from LMS 4.1. It discover only routers an...

Hi,im using Prime Network Control System Virtual Appliance Software-NCS 1.1.1 running on VM which has 16gb memory. After import some of the floorplan, i got this "Out of memory at line 158002508" error message. Is there anyone having this issue and h...

We recently had redundant sup cards installed in 2 of our 4507 units after the upgrade I can no longer change Vlan's with the CNA program.I upgrade to the newest version of CNA but that didnt helpI can still get Vlan information from my 4503's and 45...

On the 2960s 5.7.6 does not allow me to to add  the device when running c2960-lanbasek9-tar.122-58.xx and higher. WS-C2960-8TC-S     12.2(58)SE2           C2960-LANLITEK9-MSeems to work fine with up to c2960-lanbasek9-tar.122-55.SE5Anyone else having...

Hello, in LMS (4.1) installing guide, table 'Software and Hardware Requirements for Soft Appliance', it is statedMemory and CPURequirement: • 4 GB, 2 virtual CPU (< = 500 devices)Host CPU Core clock speed: •  Minimum 2.26 GHz Minimum Virtual CPU Rese...

Hello community,I have been having some problems with the syslog reports. We are running CiscoPrime 4.1. What I noticed is this:lets say a syslog message was created at 10:00 (timestamp from "show log" on the device). The syslog report showed the sam...

Hi,Can someone tell me till how much distance can we have VSL,I have 2 x 6509 serving as redundant switches and now i plan to upgrade to VSS, but both switch are 2KM away from each other.ThanksTabrez

Hi team,I have a Call manager express router to which IP phones can register automatically. The event (%IPPHONE-6-REGISTER: ephone-2:SEP0022191D02C0 IP:149.77.175.201 Socket:3 DeviceType:Phone has registered) will be there in syslog. So, based on thi...

I have been trying to remove a netflow destination.   I have been attempting:no flow-export destination internal 10.118.5.143 2055but I receive:ERROR: flow-export: destination in use. Remove all references before attemptingto delete.What command/s do...

I'm doing a large-scale snmpwalk against an ASR9k (with IOS-XR v4.2.0) running as a provider edge router (full bgp table) and pulling the full contents of the BGP route table.  On other routers, this completes within my timeout window, but not on the...

I just started playing around with the dashboard feature.  I created a new public one and then realized it had been created underneath the Medianet dashboard rather than under the root where I wanted it.  But now I can't delete it.  When I select it ...