Buy or Renew
Buy or Renew

Network Management

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

“Webinar

 
Labels

Forum Posts

Start a conversation

Resolved! INVREP0063 error Ciscoworks LMS 4.0.1

I am trying to do a detailed device report but one of my devices errors with the following:      INVREP0063: The selected device(s) does not have inventory data to display in  the report. Try to generate the report after performing inventory collecti...

Resolved! Cisco IP address

Hi! I don't know if i'm on the right thread, please move it this is wrong.I have new cisco router which is issued by ISP, the problem is i have an existing router and it has  a Ip address of  192.168.1.254now my new cisco router has an ip address of ...

eyeseven26 by • Level 1
  • 16522 Views
  • 10 replies
  • 0 Helpful votes

Resolved! Netflow Configuration on Cisco 887

Hi,I am trying to configure netwflow monitoring on a Cisco 887 router. I want to be able to report on the traffic that passes through the Dialer1 interface.So far I can only see traffic that goes OUT of the Dialer1 interface, I can't see traffic that...

Resolved! Upgrading to LMS 4.0.1

After the installation LMS 4.0 I make Upgrading on LMS4.0.1. The process remains stand with the message "File Copy in progress..." during several hours. After the Reboot of the server it points me Cisco Works again with LMS 4.0 starts.OS Version: Win...

IGOR SPANZ by • Level 1
  • 3009 Views
  • 14 replies
  • 0 Helpful votes

AAA issue

Dear all,I want to create AAA as belowuse tacas Tacas for telnet and console loginl once tacas fail, can use local different username (admin, operator ) to loginHow can I configure the switchregardsbenny

acbennyma by • Level 1
  • 600 Views
  • 1 replies
  • 0 Helpful votes

Resolved! monitoring network Latency

I want to write a script using "fping" to monitor my network latency and packet loss. since on the server I am running the script don't have root permission I can't use ICMP the other option I have TCP or UDP depend on available open port on router/s...

Ciscoworks LMS3.2 Device Support

I have recently upgraded to Ciscoworks LMS3.2 and noticed some devices are still showing as device type "unknown".  Is there an update available for LMS3.2 to support G2 Routers such as the 1900, 2900, and 3900 series?  If so, how do I go about apply...

Resolved! EEM CLI command not running

Hi guys,I have an issue with an EEM applet that I have configured. Part of the applet is to run a kron occurrence. I know the applet is executing by viewing event manager history, but when I then run show kron schedule, the kron job is not set to run...

time of netflow

Hello Everyone, I've enabled the netflow on my edge router , which, it is sends the flows to my collector ( this a linux machine with nfdump )what I wonder why the datas are appearing with time three hours later ?Each 5 to 5 minutes the collector rec...

LMS 4.0.1 do not see devices

Hello All!I have installed LMS. Then I have configured Default Credentional Set. Then start discovery with cdp and arp modules. LMS found my devices, 2 of them are reachable  but other unreacheble. All snmp settings on the devices are the same. I tes...

View All

Review Cisco Networking for a $25 gift card