Network Management

I am running LMS 3.2 with HUM 1.2 and DFM 3.2.0. I am trying to set up Thresholds and would like to have any threshold alerts go to DFM so they can then be reported to us on CA Unicenter console. When we upgraded to LMS 3.2 someone from Cisco supp...

How to do perform NAT On CSS

We are running RME 4.2. We have 4 WLCs. One running 6.0.182.0 & three running 5.2.157.0. I cannot get RME to inventory or archive any of the four. Please advise.

Hi,I need to perform an LMS 3.1 migration, and the first step is to perform a backup using the following command:NMSROOT\bin\perl NMSROOT\bin\backup.pl backupdirectorySince I already perform backups using the ciscoworks backup scheduler in Common Ser...

Hi, I have 3 WLC which i want to manage via CW but WLC shows as not supported.

We've enabled SNMP authentication traps on our managed devices. In DFM we do see incoming traps but not able to display the source of the SNMP packet. Is it possible to modify DFM to show the source device initiating the SNMP query?

I would like to create an RME job to do mass hostname changes so all our network equipment complies with our naming convention. Does anyone had an example of how to create this job using RME or if this can even be done?

Can it be done?Trying to upgrade on my ol' 2501's to 12.3 turned into such a disaster; I had TFTP checksum errors ad nauseum, and many other probs.A forum member told me the TFTP client in IOS (or bootstrap? it can't be in IOS if it's copying the im...

I started a manual backup yesterday afternoon, planning to upgrade the CM and DFM modules. Today, I saw that the backup had been created but nothing in the dbbackup.log file (0 byte in size). I tried to run backup again and got an error message. I ch...

After the upgrade from LMS3.1 to LMS3.2 the syslog file location changed back to the original settings on d:/PROGRA~1/CSCOpx/files/rme/syslogWhen I try to change it back to the settings before the upgrade on E:\CW_Syslog\syslog.log suddenly the messa...