Hi!I have ciscoworks 2.6 and HUUUUGE syslog.log file in logs directory. Doesn't cw rotate log files or something. How can I achieve reasonable sized syslog.log?thanks
Hi guy;to send a mail notification from cisco works does it discovers automatically the local mail server in the network.and also if their is no local mail server and cisco works is connected to the internet can it sends mail through the internet.i ...
Has anyone managed to restrict access to CiscoWorks successfully using ACS NDGs? According to the manuals it should be straightforward, but I can't make it work.I'm trying to give a remote office a custom role in CiscoWorks to their restricted networ...
I am not sure if this is the correct forum, if not I apologize. This is my first Netpro question and I am thoroughly confused at this point.Synposis: I have in my position several 507 content engines with CE ver 2.51. These are from 02 or so, old y...
I have started using mix of telnet and ssh for my devices in RME, I have verified that the transport protocol is set as ssh and telnet both but for the devices that are only ssh, are not reachable via cisco works, anything else do i need to check?Tha...
Hi,looking for a tool that can give me information (source, dest ...) on traffic for a specific port on a 2950 switch.Netflow is fine for ip. Something for layer 2 ?Thanks
Hi all,I have an issue with my router and im pretty new to the cisco systems so please excuse my ignorance if its a perfectly simple issue that i have overlooked.I have a cisco 877w wireless enabled router with the c870-advipservicesk9-mz.124-4.T6.bi...
Hello,I recently enabled SSL on my CSACS server and I am now receiving a "The page cannot be displayed" when the redirections from the HTTP page to the HTTPS page occurs. Is there a way change the configuration back without the web interface?
We have recently acquired Solaris Server for a Fresh Install of LMS 2.5.However going thru the history of LMShttp://www.cisco.com/en/US/products/sw/cscowork/ps2425/prod_software_versions_comparison.html1) We have decided to go for LMS 2.6.What path c...
Hi There. We have a client who is running LMS2.5 with an evaluation licence (under Licensing is shows status as SEVT). Is it just a case of purchasing a full licence and installing it into the existing installation or do we need to re-install LMS fro...
Hello !I found following problem with a LMS2.5.1 installation (and also after upgading to 2.6):RME is not able to backup the Configurations of some of my devices (19 out of more than 100)The backup of VLAN.dat and/or Running-config fails.We have chec...
Hi,When DFM sp4 became available I upgraded and ran into the same problem everyone else experienced - i.e multiple logical interfaces on the MSFC being discovered as separate entities.I downgraded CiscoWorks back to sp3 with a view to upgrading once ...
HelloWe have LMS 2.5.1 here in use. We use it mainly for monitoring our switches...Anyway, we recently replaced lots of switches and also reused a few of the swaped ones in other places. Now those reused switches recieved a new configuration with a n...
Hi all, I'm having an error regarding AAD.log and diskwatcher. It seems that log directory is full. Is'nt automatic purging of old data includes the AAD.log?Anysuggestion on how to get rid of this problem?Thanks
Hi,I am having problems running netflow on my cisco837 adsl routers (running IOS 12.3(8)T11). I am using exactly the same configs on my Cisco2600's and they work well but for some reason even though the 837's accept all the commands they are not expo...
