Hello,I'm trying to clean old software packages on Cat9300 Switch during ZTP.The command "request platform software package clean switch all" shows following confirmation prompt "Do you want to proceed? [y/n]".I tried to use an EEM script with Action...
Forum Posts
Resolved! Time of Day Routing Rules on CSR
Looking to use native CSR configuration to limit service updates based on time and date.
Resolved! unable to open nvram:/startup-config
Hi a few days ago i was asked to do a show tech to give to a support company, but the command never completed.now i can no longer configure my switch by terminal, and i cannot terminate the user sessions.i have followed all advices i could find for t...
Hello Cisco Community.I just installed a camera system on our network, 10.99.104.0/24 VLAN1. There are 17 cameras and a single Windows Camera Server. The traffic is bringing our network to a crawl. This is an MPLS circuit and setting up a new VLAN ...
Dear Team , In job of configure Archive , i get usually the result as attached for CISCO Controllerstatus of job Partial , fetch admin : Unsupported operation , fetch Data Base : unsupported Operationi don't have any idea to resolve it
Resolved! Startup-running config
Hi Experts, When I do certain changes in the CLI and then issued command copy running config startup config 1. I am understood that the running config are saved to startup config(NVRAM) and when issued sh startup, it is showing.2. Same I have done s...
Stuck on this one, I'm simply trying to configure NTP with hostnames but its unable to resolve any hostnames. I have the following commands.ip domain-lookupip name-server 8.8.8.8 use-vrf management I can ping 8.8.8.8 from my management vrf but DNS wi...
Is there a way to determine the amount of BGP neighbors per interface via either the CLI or SNMP?
HiI'm trying to find out if restconf is supported on ASR-9904 with IOS-XR 6.5.3. If so anyone knows how to configure it and if there is any special package that is needed to be enabled? What I have found is that Manageability package needs to be inst...
Hey,I am network manager in organization of 400-500 employees.There is 2 c6840-x and 15 6800ia over the building, and a while ago the developer unit came with request to sniff one port (both rx and tx) from one of the 6800ia.I tries some things but m...
Hi Team, I am trying to find the Remote device IP in LLDP protocol through SNMP, but I couldn't able to get remote device IP could you please some one help here. Below the OID's i have tried to match : lldpRemPortDesc~1.0.8802.1.1.2.1.4.1.1.7lldpRe...
Hi to All,I have a problem in my SG-500 switch when using SNMP in my network monitoring tool.I installed PRTG in my PC and configured a switch to send SNMP traffic. However the message in PRTG shows this everytime I add sensor on the PRTG server.ERRO...
I have Cisco 7200 series routers with E1 cards which are quite old. E1 cards are connected to ISP SDH network.I need to replace the routers, can I still but E1 modules from Cisco? Please provide the suitable router model and E1 modules. Also any alte...
Have a bit of an issue and was wondering if anyone has come across it We have some 9300s in our environment that were running 16.9.4 and tacacs was working fine. Our tacacs server is part of Clearpass and uses a public IP address. Since moving to 16....
