Network Management

I am having issues with a latency sensitive application and need to figure out if its network related so I am trying to see what my options are. I know IP SLA, but what results am I going to get from this? Is there an application I can run on each si...

Hi.I'm a newbie to NX9k.I was using SNMP for gather mac-address and port number. a. Dot1qTpFdbEntry for vlan, mac address and interface index b. Dot1dBasePortIfIndex for interface number (using result of (a)) c. IfDescr for interface description (usi...

I have Cisco Prime 3.2 setup out of the box with my Cisco 2960's showing up fine in the Network Devices inventory and all the metrics for CPU etc however I am not getting any client WIred Data .. my Wireless clients show up great..  Can someone help?...

Hi,I would like to monitor an ACL counter through SNMP. I found out that this is not directly possible on our device, an ISR4331 Router, so I am trying to achieve this using the "Cisco Embedded Automation Systems - EASy Custom-MIB Polling and Data Co...

Hi Admin,Do you know which tool at the moment can switch port "dynamic" to static "vlan" for each specific port?I need open sources (free tool). Because the company's budget is not available.I have switch Layer 3 3350, Layer 2 2960....If have, please...

Hi,I would highly appreciate that if you can teach me in a simple way about configuring SNMP V2 on a network device using a NMS tool in GNS3. ***If you can illustrate the process by a proper networking diagram it's better.Thanks.

I'm trying to detect when a ping communication comes back (ip sla), and then apply a "not shutdown" in a port-channel,  for that I configure a syslog event into my event manager. But it's not working. Any suggestions? event manager applet noshut_int_...

I have a template that will make an addition to all GigabitEthernet interfaces on a switch. What I need though, is how can I change a line of config under an interface ONLY if it exists? ONLY if it exists, I want to change 'authentication timer reaut...

I'm trying to transfer the configuration over from an old firewall to a new Cisco ASA 5506-X firewall. The new firewall will not taking the following NAT commands because the method to configure NAT has changed with the newer versions. Can anyone hel...

Hello Network Gurus of the world! In work we have a big audit coming up, in which we are required find what all the Machines, Floor-boxes and Ports are connected to. The current approach is going to be find each machine and trace it back all the way ...

Hi guys Our network is running out of addresses what is the best way to expand? Any help would be great