Network Management

Hello all,   I'm facing some issues with our PI and his alarm notification policies. They never worked. We were one month ago in PI 3.1 and then, we configured our alarm notification policies but they were not effective. So we opened a TAC and we wer...

We have syslog set up on a remote site - we've got an issue with ISP line going down, so obviously so does our tunnel, and then we lose syslog back to our central site.  Is there away to set up the syslog messages from a firewall so that it buffers l...

Hi,   I have certain routes learnt in EIGRP and i need to redistribute into BGP. Please note that I have to  filter just specific routes from EIGRP to learn in BGP so I use route-map while re-destributing EIGRP to BGP to filter the prefixes.   I have...

Hi,Can cisco prime infrastructure manage Cisco SMB device such as SG200 series, that support only RMON?Can it manage via web lanuch or any tools from prime infrastructure?Please advise.Thank you.NT                  

I am trying to figure out why my routers do not send traps to WhatsUp Gold.  All of my switches work properly, but the routers do not.  WUG is configured properly and each device has the right monitors enabled.  There are no ACLs on the management vl...

Hi, I'm just getting started with Cisco equipment. I need a rollover cable. As I'm sure everyone is all too familiar with, all modern laptops do not have serial connections. The majority of rollover cables I see have serial connections. Granted there...

In this post, we will try to clarify key concepts around Netflow technology and potentially correct some common misconceptions. Particularly we will explain why the “what is the sampling-rate you support?” is not the right question. We will describe ...

Hello experts,   I'm trying to figure it out a way that I can manipulate an output in a way that I can store 2 variables, here's my output:   SW-CLOSET_3-100#show cts interface summary | in MANUALTe5/2      MANUAL  OPEN      unknown    unknown    inv...

Hello community,   I'm working with Prime + APIC-EM + PnP. Devices, in my case routers, get the configuration from Cisco PI template. At the same time I'm trying to push them pki based dmvpn + ipsec as part of the configuration. The question is where...

Hi Board, I'm a little bit confused regarding Nexus 7k token based licensing in PI 3.1 (Patch 3). Here's the point: Each VDC of a Nexus 7k device is a device in the CPI device database. So in case I have one Nexus 7k chassis with a default admin VDC ...