Network Management

Hello!I have set up a database to collect desired information from Cisco prime for a long period of time.One example would be to gather interface statistics on all of our switches and then compare if anything has changed since before.Reason why I wou...

Dear Friend Recently I have installed Cisco Prime Infrastructure 3.0 for one of our customer. I add the devices and now I did configuration archive for some devices to backup the configuration. kindly please tell, cisco prime infrastructure 3.0 by d...

Hello All, Switch: Cisco Catalyst 4510R+E IOS-XE Version 03.06.03.EIOS Version 15.0(1r)SG5 I am adding some more commands to our 4500 for supporting client authentication through Cisco ISE (*RADIUS and AAA). And in the configuration guide found in C...

Hi.. Good morning i have no experience in the LMS  can please any one tell me how to take the backup for Cisco switches or from where can i see it if its already taken Regards

hello  I have Prime infrastructure 3.1.0 and i have been recently getting this error  "Component: Health Monitor, Server: Primary, Type: Process, Service:Prime Infrastructure, When: Startup, State: Stand Alone, Result:Warning, MSG: MATLAB1 servic...

Dears I have two Cisco Prime hardware servers which are working together by automatic failover  primary was active and secondary was standby after by reload the primary server, primary become standby and secondary become active since this i tried man...

Hello, I use Cisco Network Assistant 6.2 to access and see stats, port settings interfaces front panel of WS-C3850-24T model switch. It does not give front panel stats in, it does show for other new and old switches no problem

Can EEM detect the IOS version of a device, compare it to a user defined value, and send a trap if the device's IOS version does not match the standard?

I used Cisco Network Assistant on Windows 8.1 Update (64bit) for several years. On Windows 10 the installation of CNA is no problem, but only a few switches can be reached; for the majority the connection failed. Note that in CNA on Windows 8.1 all t...

Hi Team, I am working on writing an EEM script for clearing dialer interfaces as they stop passing traffic(staying in Up state) randomnly after being cleared(via a cron job periodically) and require to be manually resetted(by clear int dialer ) multi...

Hi topic: configuring snmp traps on asa managed by firepower management FS2000. We recently configured /enabled snmp traps using the Cisco FMC gui. we have got a couple of asa (thread defence devices) managed by FMC. -How can i do a test on the ASA ...

I enabled SSH access under Firewall/General. I can connect via SSH as far as being allowed to try to log in, but even though I'm absolutely sure I'm using my correct username and password, all I ever get is "Permission denied" when I try to connect.I...

I cannot get any of my Cisco 5672UP switches to respond to Prime 3.0 over snmpv3.  I keep getting Partial Collection Failure.  Does anyone have the complete configuration for both the prime side and switch side, so I can compare. I am running 7.0(8)...