Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 
Labels

Forum Posts

Resolved! ios on 2960-X

I just received a new 2960-X switch running sw release 15.0 and want to add it as a member to an existing stack of 2960-S switches.  The 2960-S switches are running sw release 12.2.58.SE2.  I'm thinking the 2960-X isn't going to join the stack with t...

phillip.b by Level 1
  • 1162 Views
  • 3 replies
  • 0 Helpful votes

Hi I useLMS 4.2, In fault Monitor I have the folowing messages : Event_DescriptionStateNotNormalDevice IP10.92.8.142Device TypeSwitches and HubsFault Last Updated At17-Nov-2013 12:36:25ComponentPWR-I@/2058 [Sw2, PS1 Faulty, RPS NotExist]Component Cla...

Hello,I have a 3750 that should support temperature readings (WS-C3750G-48TS). In fact through CLI I can get the exact temperature:show env allFAN is OKTEMPERATURE is OKTemperature Value: 40 Degree CelsiusTemperature State: GREENYellow Threshold : 5...

Hello,I will  monitor the wireless network for a few days and just that monitor  traffic and document (utilization, who was on which AP connected ..)The wlan consists of a WLC 5508 APs and 50x 2602i.how can you find over time, how many and which wire...

a-weitzel by Level 1
  • 754 Views
  • 1 replies
  • 0 Helpful votes

Hi,is supported on C4900 EtherChannel Min-Links Feature? Or is there any alternative?I have three switches, connected in a triangle, each is connected with a second 2x10GbE in the EtherChannel.I want when one line in EtherChannel fails shutdown the e...

Review Cisco Networking for a $25 gift card