Network Management

HI,Please advise the best network proactive monitoring tool, that can raise auto-alert tickets with Remedy software.Thanks

Hello allWe have a Prime Infrastructure 1.2.1.012 running. It seems that since the 1.2.1 Upgrade is the TFTP function more or less broken. I only get timeouts when trying to transfer a file from a repository. The repository server are setup with diff...

Hi,Please help me to configure CPU and Memory utlization of Line card modules using HP NNM tool.I need MIB values to configure the same.

Hello CSC We are trying to enable our HelpDesk to use LMs on a daily basis but in order to do that we would like to give them access only to some dashboards and not to all the dashboards that their role gives them access. I am sure we are not the fir...

Previously,we email to pi-nfr@cisco.com to obtain NFR license for MSE 7.4.110. We incluse MSE detail VUDI, MSE version and order no. 2 weeks ago. But until now we didnt received the mail back from cisco. Usually, how long we would received the NFR li...

Here I SSH into a radio and do the "mca-status" command.  It has a long output that gets truncated bfore it displays the items that I need to extract.  What's the best way to do this?And then I also want to post the results as a sho-run environment v...

When I am SSHed into a radio and execute the mca-status, the output is very long and is truncated.action 040 cli command "mca-status" pattern "#"Here is the output of this mca-status command.   The items I want to access are:wlanTxRate=240.0wlanRxRat...

Hi,I am using LMS 3.2.1 and unable to do the Software Repository job via RCP, because of the below error message.Problem:SW1#copy flash1:c2960s-universalk9-mz.150-1.SE.bin rcp://cwuser@CW-IPAddress:/CSCOpx/temp/rep_sw_4972128000394429365Address or na...

. .. to get the current Line Rate to then write that speed to the Bandwidth statement for an Interface to make routine protocols more accurate over radio links with varying modulations?My Googling says tells me that you can log in but any commands yo...

Anyone Knowles about Thio problem?I attach the screenshootDwiSent from Cisco Technical Support iPad App

Hello!!!After configuring cisco premium LMS 4.2 I do not have access to graphics mode when I type http:// cwlms42 1741 or http://192.168.1.200:1741But I can do a pingThank you for help me