Network Security

Our ASA box will be used by our executives to access internal data using the SSL-VPN clientless access. This means they will see the login and portal pages generated by the ASA box based on their profile. The current fill-in-the-box option of configu...

I currently have two interfaces on the PIX but would like to add a third NIC to the PIX and copy the settings on my Outside Interface to the new NIC. Any help would be appreciated.I am running version 6.3(4) with a Restricted License.

Hello, I would like to monitor the traffic that is passing through the ASA and generate reports. I have a syslog server which I sent all log messages to it. The only issue is that I can see the destination and source IP addresses + ports etc.., Is th...

How do i restore a backup config to my new pix 525?

As of yesterday I'm no longer able to download signature updates and the following message is returned:"This page is only available to registered Cisco.com users with a Cisco Service Agreement."Our service agreement is still valid. The other question...

Hello All,I have been reading some of the post about Site to Site VPN with overlapping subnets. I could use a little guidance or further explanation to understand this a bit more. To start off here is the scenario. We have a VPN established with a ve...

Hi,I got my internet link on ethernet.I need to terminate the this to my ASA 5510.Question:Will i be able to go to internet??Do i need to define name -server (i.e the DNS by isp) to my firewall?for router it used to be like this ip name-server 202.x....

Hello,I just checked one of our new ASA 5510 for the license that is configured on it. It shows a Security plus license but for some reason it shows 0 security contexts available (the device is just out of the box and is not configured yet) and there...

We recently bought a new 5520 and configured it for active/standby failover with standby ips. We tested failover and everything was fine except for webvpn. Initially, the anyconnect button was gone but after manually transferring the client files and...

Hello all I'm trying to establish a VPN with a Checkpoint NGX from my PIX and the IKE phase one works but apparently when trying phase 2 the connection cannot be established. Here is a debug message:crypto_isakmp_process_block:src:w.x.y.z, dest:z.y.x...

Hi,Need some config help on the ASA.I got Lease line link on ethernet to my premises with following WAN IP.i.e 122.x.x.114/30 and gateway 122.x.x.113.DNS server are 202.56.215.54 and 202.56.215.55.Moreover I have pool of 16 ip adresses starting from ...

Currently hosting FWSM 2.3(3) which according to docs has capability of 128,000 ACLs, but the practical number supported is about 85,000.Are the new versions of of FWSM increasing this capacity?

ok so I know that the ASA is dropping packets beacuse of an TCP MSS mismatch.and I know how to tune the ASA not to do it.but my question is based on this log, what device is setting the MSS at 1380, beacuse as far as I can see everything is set at MT...