Other Collaboration Subjects

Ok, here's my scenario.I have a VG248 located at a remote site. I can not get MOH working between the ip phones at the remote site and an analog phone attached to a VG248 (also at the remote site). Neither Multicast Moh nor regular unicast MOH appea...

Hi all,I have a customer running CCM 3.3.4 supporting around 300 7960 Phones. For no apparent reason around 30 of these phones have started resetting / rebooting intermitently. These phones are connected via different switches, and other phones on th...

I have a 1760 using H323 to do overhead paging. Has anyone used MGCP to get this to work?

I am using Tapi 2.1 and Cisco Wave driver to develop an apllication. Whenever i open a "wave/out" device associated with the line, two thread are created. Although i close the device or the line, threads are not terminated. Any clue because i dont wa...

Every now and then the Event Logs get an error that says running out of "non paged pool" memory. Recently, a publisher hung and the first error in he sys log was the following. Does anyone know exactly what this is? (meaning a comprehensible explan...

I have a MC3810 at a remote location, on our core router i have a opx plar to extend an analog line to the remote site accross the dedicated T1. My problem is i need to be able to pass a hook flash signal, the command dtmf-relay h245-signal is requir...

Hi All,I have problwm with CCME. Everytime I turn off my IP Phone, It can not register anymore. I encounterred this problem with some of the CCME IOS. The status of the ip phone is alwasy "deceased". eventhough I have reset the IP Phone many times th...

Upgraded AC from 1.1 to 1.2 and the receptionist is complaining that the AC window keeps popping up while she is on the phone with a customer using a different app. Is there a way to stop the AC from automatically coming active on a new call?Thanks

I have added the Call Back button to the softkey layout. I have also verfied all of the settings in the Cisco Extended Functions Service Parameters. Everytime I try to use the Call Back feature it says the service is not active. What step am I missin...

The following alarms appeared before the subscriber lost connectivity to the network. Although everything looked connected, it wasn't "talking" to the network and had to be rebooted. This happened several times. Are there any known issues with the ...

Hi,Can you please tell me which AXL request will give me all the IP addresses of all the registered phones in a particular device pool?I tried getPhone and I did not get the IP address.Thanks,Preethi Thamina

I don't seem to be able to select Chirp 1 or 2 anymore unless Im trying to set the default ring for the 7940, and 7960 phones... When I try to set Chirp 1 or 2 for a specific line as the ring tone, it does not appear in the list?? I thought it alwa...

Hello, I am totally stuck with a very frustrating fault with symptoms that cause on way audio. I am using 7200’s with the high-density voice modules (VXC-2TE1+). Connecting to these are Lucent Divinity PABX’s using DCS signalling. The config is stand...

How can I check if the Callmanager server a publisher or subscriber?Thanks and Regards,C.K.

I enabled MLA and put in the password like it instructed me to do. Now I can not access my CCM. How do I back out?