Here's a little background:1. Old Unity server (STEELERS) in production environment running 3.1(3)2. New Unity server (GIANTS) built with different name (for various reasons)3. DiRT backup run on old server then restored to new server4. Old Unity...
Hi,Customer has a Unity (Voice Mail Only) on ICS7750 and he wants to integrate with Novell Groupwise. I know if we can use VMI as indirect integration. However, customer wants to know if he can install "GroupWise Connector on Exchange 2000" onto Unit...
Hi,I am looking through some CM traces trying to fix an issue, but do not know what half the stuff means.for instance what does clid, nid, ct, mn, and mv mean?is there a doc that defines these values?Much Needed Thank YouFrank Marotta
Hello -For compression reasons, we implemented GSM 6.0 codec on Unity. This was the same we had been using for Avaya UM voicemail. Our IP Phone default is G.711. We are getting ready to deploy the bridge and I just saw the supported codecs are G.7...
How many phone will CiscoWorks Voice Health Monitor support? The add phone screen suggests "Maximum number of monitored phones supported" = 100. Does this mean I need another VHM server?
I have a customer that has a number of vg200's [vg200-i6s-mz.122-11.T.bin] running MGCP with CM 3.1.2c.The analogue phones seem to take between 6-15 seconds to normaly clear a call down before another call/dial tone is avaliable to the user.Some user...
I can't understand well what are the criterias to choose the most suitable server. Is there a simple relation between number of 1k blocks of RTU and HW configuration?Thanks in advance,Bye
Hi All,I have just gotten my ISDN service installed by the local Bell. Does anyone know how I take the ISDN out of the wall put it in to the Cisco 766 router and then run the POTS out of the router back through the house? Hope this makes sense. Th...
Hi, I usually configure my gateways as h323, but thought I'd give mgcp a try.The client has a PRI that will be installed in an MRP. The client is having a bunch of existing numbers ported on to the PRI. I want take those numbers and redirect them t...
Is it possible to allow/disallow inbound pots calls based on the ANI on a AS5300 within the dial peer configuration? If so how?So I can only allow calls from a certain ANI access through to match an outbound dial peer?
MisterI have two phones in a remote site , connected by PLAR CONNECTION through Cisco routers . If I am in one room and I ear the another phone sound , Could I take the call by command *1 in my phone ?Is possible to do that in the router , or is a PB...
Hi all,I have to install a UNITY Dual-switch integration whit CCM and Ericsson MD110 PBX.The computer room (where the UNITY server resides) is 3 or 4 floors above the PBX room (where the MD110 resides).Is there a limitation for the RS232 cable length...
