I am trying to setup a group so that when someone calls into my phone system and it is answered by Unity, users would dial 6 and it will call a hunt list which is 600 to ring through a couple of phones for Technical Support.
Do we have to appply a patch for DST change this November? TAC said to request patch in ten days. Are we going to have to apply a patch every time change?
I am looking for beta testers with a Callmanager 4.x lab environment to try my new AXL/SOAP application. Currently, the app can do the following:-Make copies of a phone-Make a device profile based on a phone-Make a device profile based on a phone an...
Hello, We need to set up a system that will stream videos to 3 big Tvs' the videos will be ADS that we will sell. any idea what is the eaiset way to do it? Thanks Liran
HiCan someone confirm if IPMA supports EM in Proxy Mode for the Assistant? I've got none-EM users working fine and enabled the Managers to be Mobile Managers but I get a HTML page when I select Assistant Primary Service when using EM for Assistant.
dear alli have setup VG224 hookflash for call transfer,but not workmy analog phone have identify it support 130 ms for call transfer buttompls kindly advise the example configtks again
I need to sizing a voice gateway for an IP telefony provider. He has an Ip PBX asterisk in G729 codec and want to comunicatte with PSTN with 4 E1 in G711 codec. The gateway would have to make trascoding of 120 channels.I think in an Cisco2800 soluti...
Hi,please note that my client have VG224 configured as MGCP gateway with CCM 4.13currently analogue phones can transfer but in blind mode, could it be possible to do a consultative transfer.in case yes, how to do it, i could not find any doc on the n...
Hi NetPros,I am planning to buy and install CCM 4.X or higher version on HP/Compaq DL 380 or DL 320. when i looked at the Cisco Approved Hardware requirements sheet i found the model that i am planning to buy... with dual PIII or dual Xeon on DL 380...
I am trying to migrate a PBX system to the Cisco CUCM solution with a 3845 router as the PSTN gateway.Everything is working fine except for the Polycom SP384 h.320 video endpoint which is also directly connected to the 3845 router.I can make OUTGOING...
Hii Experts,,If I have on publisher and subscribers. The publisher scrashed or dameged and I have backup. What are the procedures to bring the PUB up again. Thanks..
Dear Networkers,Can anyone help me if we can use any non Cisco Wireless IP-Phone with Cisco Call Manager 5.3 and POE Cisco Access Point ?Since we have a security issue in our country and we cannot use the cisco IP-Phone,Thanks all
I have a pge which has a dial softkey. After I pressed the dial, the service stopped and I couldnt get back to that page. Are there any way to keep the currect service page after dial?
