Hi, im running CM4.1(3)and version with 7.0(3.0S)for my 7961s. I am running into an issue where the hook switch becomes inoperable and the only way to answer or initiate new calls is to use the soft keys. A hard reset of the phone fixes the issue but...
Hi,I have just installed CM5, and have 3(IPC, 7940 and 7912) phones auto registered to it.I have a SIP trunk, that connects to a third party SIP application.When I make a call over the trunk, the calls go through fine.However, only on the 7912, the a...
I am new to VoIP & trying to configure a CCME system on a 2621 routerMost of the basic configs have been completed.I have successfully configured a POTS dial-peer and able to dial out to the pstn from the VoIP phones. But iam unable to dial from outs...
Hello,It's possible to configure the Cisco IP Communicator to list the local directory confgured on the CCME 4.0? On 7906 and 7940/60 the local directory is enabled by default but not in the CIPC.Is There any way to change the language on the CIPC?Th...
dear sir, Any one have any idea how to change the the ccm & unity administrator password? Any negative impact to perform the task? Please share. thanks.
Hi forum,I have SJLabs phone configured as Terminal, it registers fine in the Gatekeeper.But in my SJLabs phone I dont have an option for selection a Zone.How can I configure the GK to register the Terminal in a particular zone.Now its like selecting...
I have a 2600XM running CME 4.0 and a 1760 with 2 FX0 and 1 FXS card. Both routers are running IOS 10.4(9)T. I would like the 1760 to act as a gateway using H.323. Can anyone advise me on how to set this up?
Running CCM 4.1, we have some alerts setup in RTMT to email people when certain events happen. The schedule feature only allows us to set a begin and end time per day and doesn't allow us to exclude weekends. This causes people to get email bombed on...
Is there a way or ideas on moving the Corporate Directory to the Softkey, make it a one touch button to get to the Corporate Directory? Right now, as standard, users press the Directory button, then they choose the Corporate Directory option. I have ...
hi,there is way to avoid the registration of pots dial-peer to the sip register server defined in sip-ua??to avoid ephone-dn registration there is the no-reg option .. someone knows a similar ay for the pots dp??thanksstefano
Hello guys,I am installing a brand new CCM 4.1(3). When I go to the Cisco OS Version, I see Os Image 2000.4.3a is installed. Do I need to install the service release 2000-2-7 sr2 or later? Or it's included with the image 2000.4.3.a ?Thanks,
Hi All,I have a customer that we've quoted CME (CallManager Express). However, they may migrate to a centralized CallManager architecture at a later date.Is there an added cost to move to SRST at a later date from CME? thanks,Paul
