Other Collaboration Subjects

Hi all, I have a problem with a CME, I put a telephone on remote site, and I create a VPN between 2811 (with CME) and 837 (on remote site) and it's ok, the telephone go on and register on CME, it can call the other telephones and use voicemail etc, b...

I currently have a small network with 2 routers, each running their own gatekeeper. I've set up a single multicast paging-dn on both routers so that all the ip phones on that zone can be paged. Any phone from either zone can ring either paging number...

Hello,I'm not able to place an outbound call with a Cisco 1760 connected to an Alcatel Omni PCX office 100 with a VIC2-2BRI card.Here is the Q931 log :*Mar 6 04:02:59.623: %LINK-3-UPDOWN: Interface BRI3/0, changed state to up*Mar 6 04:02:59.691: IS...

The FXO ports are connected to a telecomms company. The telecomms company has a service whereby dialling *21* followed by an external number, all call would be forwarded to that number. To cancel the call forwarding you would dial #21#. How do I tell...

I have a cluster ,one publisher ,two subscribers,and I configured RAID on each callmanager machine, I aslo setup BARS to backup the data. I know two subscribers are redundancy, but only one publisher in the cluster,I enabled Extention Mobility Servic...

Hi,Need to configure multitenant for a customer.1. having different hunting no (general no) for each floor2. having different voice mail no for each floor3. have own directory for each floorAnyone got any sample doc for the CCM and voice gateway will...

Hello all!I have a valcom paging system off of an FXS port. Calls come in, are transfered to the FXS port (x250). The ring voltage causes the paging system to emit a warble to tone so the plant floor knows the phone is ringing at night. The proble...

Anyone seen a CCO doc on limitation/interactions of Line Groups in CCM 4.1? I recall briefly that you can’t be a member of more than one Callmanager line group, anyone tried this? Once you ring Line Group A and move to Line Group B, there isn’t a way...

This is 7960 configured for receptionist, and also has attendant console. CCM is 4.1.3(sr1)."Transfer" softkey is missing when pick up the phone call.

I only find documentation for the 7970 phone to support SRTP. Will Cisco ever support SRTP for the lower numbered models?

Hi,I want to install subscriber Cisco CallManager in our network. I want to know whether i need to do the same configuragtion that i have done in my publisher server? Plus i want to install Cisco CRS 3.5 software in my publisher and subscriber server...

I need to connect CCM to a 3rd party H.323 gateway. The gateway supports G.729A. If I do not set the gateway in CCM to require a MTP, G.729 is negotiated. of course then hold or transfer drops the call.If I do set MTP required, the rtp stream is s...

Hi, i did a factory reset for a 7970g ip phone and it never loads again. It gets stuck in a presentation screen where is the Cisco and Java Logo also each line button flashes on and off in sequence in yellow. What can i do??? Please help me i will ap...

I'm using a ata-186 with SCCP across a WAN link. I have the LBRCodec set to 3 so that G729 can be used. My problem is that I cannot find any way to stop G711 from being selected first. There appears to be no documentation on forcing an ephone to use...