Does Vg 224 support the SRST , if yes then what is the way to make it capable for that.If not , then is there any plan to intoduce this feature in near future ???
I am attempting to upgrade the license on a CUE AIM card using the sofware install clean url command. When I attempt to do this I get the following error message:Online install/download is not allowed due to insufficient FLASH capacityI have a 512M ...
have two dhcp servers on the network. one is the call manager and the other the data dhcp server that was in existence before. have configured vlans on catalyst switch and both are connected to that switch. issue is that if the main dhcp server goes ...
Hi,i have cisco MCS server with cisco call manager 4 install in it. i have purchase the h.323 service they give the one inbound no. and outbound prefix. anybody tell me how can i configure the these No. on MCS server route pattern field. i have assig...
We have several hunt groups with algoritm longest idle. When a call is forwarded to the hunt group and no one answers the call is dropped. In the pilot point is configured with forward no answer to a internal number. When you call internaly to the hu...
Hi all,I'm currently experiencing problems with time of day routing together with a PP!I would like to configure the following:During office hours, an incoming call should be placed in the queue for the Pilot with MOH. However, in the outside office ...
Hi ,How can I configure the second line/button for 7940 Phone as a trunk line to PSTN ? I know in CM u need to configure the phone template to use the second line.ThanksBrgdsRenzil
I need to know of a way to change the MOH volume in express. I have had three diffrent customers complain about it being to loud for them and do not know a way to turn it down. If I have to download the file and rerecord it what program do you sugest...
HelloWhat is the role of OPX in voice gateway?what is the meaning when opx has a value like: opx=9, opx= 602,602,603 ?why FXO has OPX value but in other hand FXS Doesn't have OPXPlease could you helpthanks a lotzahida
I am designing IP telephony environment for hub and spoke frame-relay environent where CCM cluster is located at the hub site. There are 13 spoke sites ranging from 5 to 130 phones. Is there a rule of thumb on how many concurrent calls are active b...
Hi all,I've searched the forum, the whole internet and the Services development book but i can't find any information on how to display another font on the IPPhone.Also the image conversion through CIP is very poor? I've used a Gif image 130x60.Could...
Hi,I am running my Call Manager and the IP Phones behind the NAT. I have cisco 2621XM router with 12.3.14T2 IPVoice IOS. Call Manager is configured with static NAT while IP Phones are on Dynamic NAT. H323 is used for call setup.Randomly, the router s...
Hi All,A customer of ours uses the ART software to pull information out of the CDR database once a night as it is meant to do. They then have a small MSAccess front end to query the ART database for generating reports on which phone used what amount ...
