Other Network Architecture Subjects

hi i have two 6509 connected to two cat4006 . Each has got trunk to each other. The multicast server in on one cat6509. When the client in same vlan on 4006 joins the group it works, but it stops working then.Only way to get it owrking is to reboot ...

Please send me the following specifications regarding the 2651xm:Cosine of phi.PFC - power factorCurrent requirements at start upAltitude:Non operating

I have a question concerning quotation in SSG.As we know biparametrical quota is not supported. And we are goung to usesession-timeout for this purpose.The question is whether AAA server response allow to set session-timeout andQuota attribute with q...

Hello, My name is jado ku.Current spec of Catalyst6509 is following list.-Chassis W/1300W AC Power-1300W AC Power Supply-Catalyst6000 Sup. Engine1-A, 2GE, Plus MSFC2&PFC-Catalyst6000 MSFC2 IOS Enterprise-Catalyst6000 8Port Gigabit Ethernet Module-100...

Is there a way to have the CW2000 R5 server on a Win2k server show up on the topology services network layout???TYMike

Hi~Their are two routers which have multiple routint protocol, RIP, EIGRP, IGRP, OSPF, no redistribution each other.At every router, 'Show ip route' show the table of eigrp's routing table.At this time, each routing protocol have their own routing ta...

we are old NM-2CE1U module insert to 3662 router.router display login infomation:%CONTROLLER-2-FIRMWARE: Controller E1 5/0, firmware is not running\parhelp me

Customer has two ISP connections to his home. The 1st is a Cable Modem attached tro a 1710... the PC gets it's IP address via DHCP. Customer wants to connect his DsL connection to a new 831. The DsL provider is providing a static IP address. Customer...

Hello, when I do a show log on one of my C3550s on a console,the following message appeared :=========================================================Apr 17 01:18:01: %SYS-2-MALLOCFAIL: Memory allocation of 1680 bytesfailed from 0x152778, pool I/O, a...

I am getting error message from NMS,here is the error messge: ========================================================= Apr 17 01:18:01: %SYS-2-MALLOCFAIL: Memory allocation of 1680 bytes failed from 0x152778, pool I/O, alignment 0 -Process= "IP Inpu...

I have this error message when i try to configure the AS2511 for the first time :"can't find master interface for async IP support" and the setup program stops.It is a hardware problem ?

Hican any one help me in starting to apply QoS in my network.i read about QoS and i understand it to a good extent..but actually i got lost in doing a case.i mean i want to know what shall i do exactly, ACL, Filters, Classes..and QoS parameters.if th...

We did a hot-swap replacement of a 10/100 48pt (WS-6548) card in one of our 6513s last night and noticed an interesting quirk on our servers. The card replacement went without a problem and the sho mod and log buffer looked good on the cat; however ...