I don't Know if ppossible but someone say ..Yes ! I have a Router 1751 with Serial and ISDN Interfaces.It's possible when the Serial line is Load (255/255 or 200/255) expand the Bandwith available with a ISDN BRI call ?????If Yes, .. How .. !!!!
It confues me at the moment whether cisco 2950 switch or 3548xl is a layer 3 switch. (Do they have routing function?)I can put the following commands into 3548xl switch:int vlan 1ip address 10.1.1.1 255.255.255.0no shutint vlan 10ip address 10.2.1.1 ...
I have 2 Catalyst 2950G EI with WS-G5484 but I need to know what type of end they are going to need on the fibre. I Was able to pull the type of pibre that we needed to run off the web site but couldn't find anything about the ends. Thanks
does anyone know of an article that shows how to configure a cisco vpn 3.x client to a router without radius or anything. just an ipsec tunnel? thanks!
I have trouble getting the BBSM server functional. Hope someone can help me. We have installed and configured BBSM 5.2 software on a compaq proliant ML 370 server following the stpes in the installation and user manuals. Now none of the clients can b...
Hi,I've make the follow configuration:user-modem ---- PSTN ---- Cisco 2650The Cisco 2650 had another modem attached to the AUX port. I call from user-modem to Cisco 2650, and I can connect to it. This scenario works OK.Then I've tried the configurati...
Hi AllI have three routers (2 x 3550 EMI and 1 x RSM). I want to run HSRP between all three of them - for load balancing.HSRP has been configured to run between the one 3550 and the RSM. When I installed the second 3550, it only shows that all its VL...
I want to add a distribution layer switch to my LAN. right now its two adjoined buildings... one subnet... no routers... except server based router for firewall/internet proxy. Under 50 node network. approximately 35 nodes... 3 main servers. Right no...
Hello,A Question on IP prefix listNetwork mask assigned is /25.But when am configuring the command,i use the network mask as /24,say..ip prefix-list list-name seq seq-num permit x.x.x.x/24 le 32What would be the effect if i use /24 in the ip prefix-l...
Hi all,I found "wrr-queue"command in my switch but I can not found that in my router, does router can config wrr-queue? if it can, so which version of IOS can do that? Thank You!Best RegardsWaimen
Hi;Any body has explanation for (B/w changed) port state message when using dspports or dspport ima group # in AUSM MGX service module card .Thanx in advance
I have 1 (out of 182) dlsw peer that connects to a CIP, over a WAN, that refuses to stay connected. It will connect and then disappear at random intervals, never more than a day. Any ideas as to what the causes may be will be welcome. I am loathe to ...
I know a Frame-relay circuit provisioned with a CIR of T-1 is 192KBps (1.5Mbps/8bits). In one hour, 694800 KB (679MB) can be transferred. However, how much of this 679MB is used by SMB, UDP, IP, and Frame-relay? I need to know the net amount of da...
