Other Network Architecture Subjects

I recently did a show interface stat and obtained the following. From what I can see it seems as if we have more of our packets being processes switched rather than fast switched. I know this should no be the case as we are using MSFC in Cisco6509 Sw...

this is what i recieve on the reload of a cisco catalyst 2950xl any ideas why? or is it just cause they are dead?C2900xl POST: Ethernet Controller Test: PassedC2900xl POST FAILURE: front-end post: FastEthernet0/9:C2900xl POST FAILURE: looped-back pac...

My syslog file continues to grow, however under the administration/sysloganalysis/syslog collector status all the messages show up as invalid.If I open up the log file manually, the data appears to be ok, (it shows strings you would expect to see) bu...

When loading ciscoworks2000, I was never prompted for a servername. I did receive a message stating that my DNS was slow or down during the initial load of the software but the installation continued. It told me I could correct this later. I tried...

I get the following error message when I insert PA-2FE-ISL-TX into a 7206 VXR NPE-300. Cisco recommends that I call the TAC but wanted give the forum a try first. I got the same result on other 7206 routers. %PA-2-UNDEFPABRIDGE: Unsupported Port Adap...

I get the following error message when I insert PA-2FE-ISL-TX into a 7206 VXR NPE-300. Cisco recommends that I call the TAC but wanted give the forum a try first. I got the same result on other 7206 routers.%PA-2-UNDEFPABRIDGE: Unsupported Port A...

hi,my problem:i have a 3640 router which has a "production"-dlsw connection to a 7513 router.i also configured a "backup"-dlsw connection to a backup 7513 router with the "backup-peer"command.everything looks fine - if the prodconnection fails the 36...

I know there is a way to create a webpage for syslog in CiscoWorks but I know nothing about scripting and Pearl. Does anyone have any suggestions or any samples you could give me? thanks

How to implementation the ssh protocol to access switch console 2950,I ´use ios Version 12.1(11)EA1.

How to implementation the ssh protocol to access switch console 2950,I ´use ios Version 12.1(11)EA1.

I'm using the "management station to device" Connectivity tool, but keep getting "Unknown community name" error on the devices "sh snmp". I've retyped the community name serveral times, but keep getting the same error. Has anyone had any similar prob...

our network is as such:2 6509, each with 2xsup1a & msfc1.Is it correct to use exactly the same configuration in both msfc in same chassis, or should they be configured to do hsrp between them? can someone also give me an answer with my previous topic...

Hi ,I have two identical router and want to transfer the configuration from one router to the other, is there anyway I can do that ?Pls advice. Thanks