Other Network Architecture Subjects

In the past day, a Catalyst 2924XL-M that has been running smoothly for over 22 weeks sudden started generateing LINK-4-ERROR: FastEthernet0/x experiencing errors. These messages have been coming up every two to three minutes over the past day. It ...

Howdy,If the following from CCO is true:For priority, the range is 0 to 61440 in increments of 4096; the default is 32768. The lower the number, the more likely the switch will be chosen as the root switch. Valid priority values are 4096, 8192, 12288...

How would we do a rate limiting for broadcast and multicast frames. Would that be advantageous to such a thing. I do know some protocols use multicast to send queries. Thanks.

I've read several threads here about flapping mac addresses and I understand the causes, but I have two situations where it is occurring but I dont know if its really a problem.First I have a 4006 in the center of about 20 2950 and 3548 switches. Th...

Is it possible to monitor eigrp neighbour state change via SNMP or and SNMP traps?

When i Launch the server on port 1741 the browser window gets inmediately closed. I´ve installed LMS and RWMS (CDONE 5th edition)I´m running Netscape 4.76, java plugin 1.3.1 on Solaris 7.

I like to configure a E1 PRI between 2 routers so that the B-channels are only dialed when needed. So start with the B channel 1, when die Bandwith goes over 64K dial the second one and so on (like ppp multilink with dialer-load-threshold for BRI). I...

Hi.* Is it possible to configure span on one of the ports in an etherchannel (created of 4 phisical ports on CAT6500 running IOS)?* Is it possible to configure span on an etherchannel?Thank you.

the catalyst 3524's flash system had destroyed and cannot normal run , I want to copy the new iso to 3524's flash, pls help me .thanks2002/11/10

After upgrading software, "show logging" no longer lists the pagp facility and there are no more "%PAGP-5-PORTFROMSTP:Port 1/3 left bridge port 1/3" messages in the log...

I need connect a sever with two fiber NIC to a catalyst 6500.I want to work a 2 GB with load balancing. Is this posibble wtih fiberchannel ?How can I configurate the catalyst ?Regards

Are there any performance stats for the 827?Im wanting to run one for say 10 clients all using NAT and I need to know if I'll be able to fully utilise the 2mb ADSL pipe we are getting, or whether the overhead of NAT would be a problem or not.I know i...

I'm trying to develop a test scenario for pass/fail testing of some questionable GBICs. We've had a series of both complete and partial (one phase of three) power failures, and some of the links did not come up when power was restored. My test-bed ...

I get the error " error -14 open device bootflash failed (no more file records)" when I type in the command dir bootflash: on a Catalyst 4006. I am in the process of installing the CWI and need info contained in the bootflash. What would this error ...

This may be a little lengthy but hopefully someone can point me in the right direction. Scenario: I am located at a facility that has a point to point frame relay line into a customer site with a FTP Server that I need access to. I actually target...