Other Network Architecture Subjects

Last week our organization upgraded from CWSI 2.4 to CWSI LMS 2.1(5th ed. CD). We are getting complaints from users that the CWSI server ishitting non network device hosts (workstations and servers) with ICMP packets. Would appreciate any insight i...

Does anyone recognise the following error when communicating with the ANI server?AniWrapper>>analyze(SYSTEM)Server Named: ANIServer4.0-ukhwnms01 on port: 14004TIA

If an optional transitive attribute is not recognised, it is passed on with the partial bit set. Does this bit get reset at any time by the downstream neighbours, and if so, please state under what circumstances that will be

Hi folks, I have a home network with two 2600s and a Linksys router. I have three subnets. If a client is on the first subnet it can create a VPN tunnel (using IPSec) to my job. However when I move that client to another subnet (Over back ...

satellite modem--------------------------router----------------server(multicast station) | | fast ethernet0/0 cisco 2611 | fast ethernet0/1 | pc when pc connected to satellite modem,...

Hi,I just went through this document:http://www.cisco.com/warp/public/105/queuing_fr_interfaces.html#ifaceIs it correct that we have 3 queues with frame-relay:PVC queueinterface queuetx-ring??Alex

Hi,I'm testing a VPN product through a Cisco 765 M ISDN (c760-i.b.NET3 4.3(1)) router configured with ip pat. The key exchange (using UDP) works like a charm but when trying to communicate through the tunnel (i.e. sending ESP packets through the rout...

This is a basic question, I need clarification on a scenario.I have an internal network which is protected by pix 506, pix 506's outside interface is connected to a hub which is having one cisco 1603 connected to internet leased line, and also one ci...

When configuring ISIS in a multi-area environment I have a questionWhy would you set the first ISIS process to be a L1L2 and not just a L2?I've been reading some documentation on CCO and it says the first area should be a L1L2.see below for config !r...

I am wondering if any one has seen this problem before. We have 2950s that users are reporting of being droped. When investigationing they are still connected to the switch and they are in the the right vlan. But for some reason there mac address ...

I have a port acl applied to an uplink port on a 3550-12T switch. The extended ACL is fairly basic. This ACL inspects the packets coming inbound to the (uplink port ,gi 0/1) on the 3550 switch. There are several servers connected to the device. Traff...

Is there a way to discover what IPX network number is being used on a lan segment from a cisco router?Frank

My company has a cisco 2621 router with one s0 and 2 Fast Ethernet ports. here is the scenario, one side of the network is 10.0.0.0 with subnet mask at 255.255.255.0 running an NT 4.0 server /with dhcp running and use 2 24 port hubs. On the other sid...

Is it possible to pre load new IOS's on a pcmcia flashcard from my windows 2000 based laptop. Or are the files sytems completely differnt (win2k vs. cisco filesyste)? I am loading the flashcard into my laptops pcmcia slot.Any info would be greatly a...

For example, VIP4-50 can switch 100k pps, RSP4 and dcef is used. Then, RSP offloads the switching process to the VIP4-50. If the swithcing rate of that VIP4-50 exceeds 100kpps, will RSP4 just load share the exceeded packets. Say, 200kpps input rate i...