Other Network Architecture Subjects

HiI have 2 leased lines connected to different internet providers on my 2610. I want the router to loadbalance between those two according to the load/delay/(line quality :response packets of the line or request packets lossed) , to have one high qua...

hi,I am trying to tftp the startup-config file from a Cisco 2600 Router over the internet [i.e from it's outside interface - the access-lists allow port 69 from and to any address 12.1(7). When I try to execute copy startup-config tftp in priv exec ...

Hi allI am wondering if someone can help me with the following situation or if there is any documentation on it somewhere.We have 2 buildings connected through a T1 line. In building 1 we are running Windows NT 4.0 Terminal Server running DHCP. In ...

I have a module on 7206 VXR, PA-4E1G/75,but i do not know what cable i should select for this module ?any helps? thank you

Are ATM PVC's considered secure or should some type of encryption be enabled on the edge devices.

I've just converted all of our WAN from 3Com gear to Cisco. The hub is a 3661 with multiple T-1s coming in and the far end sites are 1720s, mainly T-1s but a couple 56Ks also.On the 3Com gear I could enable compression (software)on a per-packet basi...

This may sound dumb but... I have a Cisco 2600 and need to do some filtering of ports and IP addresses. Not really sure what the command is to do this. I can telnet to the router and have all the right passwords but need to know how to set this.An...

Is it possible to put tresholds on catalyst utp ports so an alert will be sent when it generates a certain amount of errors in a period of time. Can Cisco works 2000 play a role in this or is there third party software which can do this tasks.

Can somebody tell me what encapsulation is used in a PAMA VSAT connection. Is it PPP or HDLC or other

I would like to connect a 3640 and 1720 together, I want to simulate the t1 connection. On routers with a v35 connection i know its possible to use a dce cable on one end and a dte cable on the other end. I saw someone mention a rollover cable or c...

I recieved an error in CiscoWorks with a "HIGH" severity. The error said:"Trunk port 16/1 belonging to device xxxxxxxx has spanning-tree portfast enabled"I know this is not a good thing, however, I do not have a port 16/1. The device is a 6509.

Hii have 1 cisco 1603 and 1 cisco 2621..they both have eth,serial and bri interfacesthe routers are connected with a leased line and i need to configure backup isdnthe 1603 will use one line to connect to the 2621 and the 2621 uses 1 of his channels...

Could a 6500 switch or 7500 router using 2 DS3's WAN ports, multiplex 2 DS3's lines to provide almost wire speed 100MB ethernet bridging?

I have been in many discussions about setting my switch port speed and duplex to auto or fixed. My take is that the rule of thumb is for workstations or PC's Is to set it for auto. Servers should always be set to fixed. I understand that this is the ...

How can I route these vlans so they can talk to each other. I'm doing this on a 6509 switch with a RSFC.I've set up vlan interfaces with IPs on the layer 3 side of the switch but cannot ping from one vlan to the other.Vlan 200 IP-10.2.253.253/24Vlan ...