Routing

  I would appreciates if someone have a document listing what kind of test would be recommended in new data center acceptance delivery  ( what kind of test shall we tested to verify the success of connectivity , redundancy and integrity ) , please if...

Have client with current Cisco 2851 router(s) running AdvIPServices, also have some CISCO2921 router(s) running IPBase with Data License to provide DLSW bridging path for some remote site HP DTC coverage. Time to upgrade the 2851's and would like to ...

I have a client that ordered the following 4G LTE card for their ISR: EHWIC-4G-LTE-BE            4G LTE EHWIC BELL CANADA, LTE AWS / HSPA+ The issue being is that the provider they are going with is Rogers (not Bell) and were wondering if the card is...

When i run tcl script command " scripting tcl init flash0:bvr_pe01.txt "after i run command " tclsh " router restartI don't know why ?File script tcl as attach below Please view and reply! Now i am confuse about it

I have two ISP's - one via Dialer 0 (ADSL) and one via DHCP (FastEthernet 0/1).  I can selectively route outbound traffic using route-maps and ACLs but I can't figure out how to nat inbound traffic from either public interface to a single internal se...

We are looking to set up some testing tomorrow for a few net admins and I'm trying to figure out ways that will force admins to use troubleshooting techniques rather than referencing a known good running cnfg. For example, I can put incorrect AS numb...

-  i configure vlans and inter-vlan routing and its working well.- i  configure default route to pass the packets to another interface ( no switchport , ip address and route are configured)the problem now that :-from the 3750x router itself; i can re...

I would like to know how many users are connected using the command line access (ssh).Is it possible?If yes, what is the command? Model: AIR-CAP2702I-Z-K9 Thanks,  

Hi,Sorry if the is posted in the wrong community. Can anyone please help me out?  I have a Cisco 877w router and is trying to configure it for ADSL. It manage to connect but disconnect every few seconds just after it connected. While connected I am a...

hi fellow networkers, i wonder if you could help me with a crash that happend to a router i manage, the router crashed without human interaction, all of the sudden it reloaded, any advice will be greatly appreciated.please see attached file of crash....

Hello, I have a Cisco 881 router connected to a 10Mbps WAN. I am trying to set up traffic shaping. I am trying to establish the correct burst value to use within the command 'shape average x x'.In order to do this, I understand I need to establish th...

Hi any  show command is there to see routers uptime other than "show version"?????