Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

hi guys, I'm learning from CISCO materials and wondering about this statement. "Organizations can lease public addresses from an SP, but only the registered holder of a public Internet address can assign that address to a network device".  Router R1 ...

Hi to everyone !!! Im using Cisco routers for a while and really happy about performance and funcionalities ! What Im facing is a problem in a branchoffice that has a 891 router in the edge. This router is working fine but i think Im arriving, as gro...

ahorta001 by Level 1
  • 762 Views
  • 1 replies
  • 0 Helpful votes

I have an ASA 5505 that is periodically restarting a couple of times a day. I have disabled logging and am planning on updating the ASA here soon, but after looking at the crash report am not convinced that is the main issue. It is a remote location ...

Hi I have a cat6500 and need create a route-to-route vpn to allow remote smail office backup to main campus. the office is located into another organization. I want a our subnet/vlan to extend to there. traffic on both direction, and require remote o...

julxu by Level 1
  • 297 Views
  • 1 replies
  • 0 Helpful votes

We have a bandwidth issue getting from our colocated site with an ASA5515 configured on 0/2 for a 20Mb E-line to our corporate office. We have Level3 as our provider for the e-line.The issue is that we have between 1-5mb speeds copying a file from on...

I am looking for a router that can handle up to 1 Gbps of encrypted traffic across a GRE over IPSec connection.  We are currently using a 2951-SEC/K9 that tops out at 80 Mbps @ 70% CPU.  I have been looking at the ISR 3945 but question if an ASR 1001...

Resolved! Downstream BGP

We have a client that we are looking to provide Downstream BGP. We have BGP session on a single router with 2 Major carries. Can someone give me a sample config to allow our client to peer with us via BGP. We would like to set them a default route in...

mspdog22 by Level 1
  • 1954 Views
  • 3 replies
  • 0 Helpful votes

Hello, first of all i'm not sure if i post in the correct forum part but I hope it's OK. We have an application that uses RTU (remote terminal unit) connected to serial interface of Cisco 819 ISR (C819HG-U-K9). We want to be able to send and receive ...