Routing

A student entered login local at both console and vty lines. They did not setup a local database. How can I get around this and still save the configuration? The router is a Cisco 1841. Thank you in advance!

Hey Guys, I would like to block ping in the same network, we have Guest Network 10.x.x.x/24 and we dont want them to contact each other computers. We dont have FW and only can use Routers. Could some one tell me how do I do that, should I use ACL and...

Hello, I have a conundrum on my hands. I'll do my best to explain this simply. We have 2 datacenters (I'll call them BP and CG). Between these datacenters we have a private circuit that connects them. At each datacenter, we have a WAN router that goe...

 Hi everyone  i have a router 1941/K9 with card EHWIC-4SHDSL-EA ,i have configure this card in my router , the problem is I can not ping the ip @ Neighbourhood and the MSAN can't also  see the mac-address of the router  do you notice that the interfa...

Hi, Have an oldish 7200-G2 in the lab that I need to setup with test peering with an AS larger than 65535 - It does not accept asdot notation (i.e. throws an error when I enter the converted AS - It doesnt like the ".").  Is there any work-around to ...

HelloIm having some problems lately with our new site network configuration.We have there new Cisco 891 router and from isp we have Zyxel P-660HN-T1A router/modem as isp connection termination and one public ip from isp.Problem is, how to setup route...

Can someone  answer this question We have a Firewall that runs OSPF on multple interfaces.One of the interfaces is connected to a 6500 switch which also runs OSPF.The Firewall Distrubutes routes to the 6500 switch which is corrrect,.But I dont want t...

this is my config, trying to failover using WAN links between two sites , two c3750x one at each site. connected to Internet via Watcghuard XTM 505 devices and connected to each other for WAN -point to point link, that i want to use for failover.it d...

Hi, This is my 1st time setup dynamic routing. So please help me out.Attached is my diagram. Take a look.We have a new WAN connection. I setup the new WAN connection on my test router as the current connection is in production and use static route be...

Dear All, Can you tell me, is it possible to add one E1 / Module on 2811 Router. Will it support ? Is there any impact due to that? HQ#sh verCisco IOS Software, 2800 Software (C2800NM-ADVENTERPRISEK9-M), Version 12.4(17), RELEASE SOFTWARE (fc1)Techni...

I have a problem with HSRP routers becoming both active and rebooting on their own.The message occurring after the self reboot is the following:"Reload: Self Reload. Reason: Not in correct state for becoming standby."Is there any reason for this to h...

Hi, I am successfully using IP SLA and EEM for failover. I mean to say that i am monitoring one live public IP address with primary link. If that link goes down, the backup link must goes up by using Event Manager commands. But when my primary link g...