Routing

Hello experts,Currently I must wrote in a document the seconds how long does it take when rapid-stp and hsrp converge. Let's say there is a high delay sensitive conncetion only within a VLAN. The vlan is spanned over 4 nexus 5k which where two n5k co...

Dear All,We have recentrly replaced a 1700 router with Cisco 3945 router (Core Router) and the Channalised E1 interface is configured as given below:no network-clock-participate wic 0 !controller E1 0/0/0 framing NO-CRC4 channel-group 0 timeslots 1-...

Dear all,I have an 1921 that I use for L2TPv3 tunnel connection with 2 sides. I need to add others 2 sides and I thought to add an EHWIC-4ESG on my router. Can I configure different xconnections with this module? I would like to configure my router a...

Dears,how can I notify my syslog about router bandwidth utilization ?           

Dear All,I have cisco 3845-Hseck9 router having the ios :C3845-advipservicesk9-mz.150-1.m6.bin.If this IOS will support IPV6 implimentation.If it wont support please which version i have to purchase.plz help meThanks & RegardsSrinivas

I have a few datacenters within my company.  In one DC, we own a BGP AS and the pubic IPs. That DC gets internet locally and services customers in the local area.  In another DC, we have our own BGP AS as well, but we lease IPs from two providers.  W...

Hi All,I have a production L3 3750 stack with 2 WAN connections, which is connected to the companies WAN infrastructure using EIGRP.Recently there have been a number of hello drops from one site, which is causing the EIGRP adjacency to drop and so th...

                   Hi Geeks,following is my setup on ASAinterface GigabitEthernet0/1.20vlan 20nameif ABCsecurity-level 100ip address 10.20.100.1 255.255.255.0interface GigabitEthernet0/1.30vlan 30nameif XYZsecurity-level 100ip address 10.20.200.1 255...

Hello;I am stumped here. I need to open ports 9080 and 5280 on my Cisco ASA 5505 firewall and despite doing everything I THINK I needed to do...when I run the utility to check from outside; it is NOT open....I utilize a website called http://www.youg...

Hi All,I'm facing a really strange issue. I have an old 2621xm router in CCIE lab at home. Only a week ago I started having issue on 2 of them. The problem is on one of them when I go under interface configuration and I type "no shut" nothing happens...

I configured a Cisco 861 router to allow only youtube.com and block all other URLs.I used the below configuration but is not working. Actually everything is blocked even the access to the router.Is there any other way to acheive this requirement?clas...

Hi Team,I would like to configure a Management ip address on 6500 by giving ip to the SVI. Following is the configuration done1) int vlan X    ip address 10.1.1.1 255.255.255.0    no shutHowever i am not able to reach this Switch IP from other subnet...

I have a requirement to filter the next hop information from multiple route-map entries.e.g. show route-map NAME | section sequence 10Which gives me the output for sequence 10. I then want to match further to just get the next hop for that sequence s...