Routing

Hi,Have several sites and all seems to be up and running,except one that is site  B...same configuration as othersit has intermittent disconnection on VPN,as the ASDL port of the router does not work(interface BVI1 is down even if u try to bring it u...

Hi:I am having problem with our router which have dual mpls link.The issue is that the primary mpls link is having bgp flapping issue while the secondary mpls link is not. We are using same standard bgp config accross the board. We have tried changin...

The situation I've been asked to address using QoS is to design a policy on the WAN router at head office to address the following requirements:Not allow head office to overload remote site WAN 1Mbps connections (i.e. shape average)Give priority to c...

Not sure if this is the best place to pose this question but I am wondering what other people use for % of bandwidth used on a circuit before upgrading?  For Example we run reports that we flag at 65% full.  This just means we will watch the circuit ...

Hi network gurus,How is the processing order of nat rules with routemaps determined?(part of the configuration)interface FastEthernet0/1 ip address 192.168.1.1 255.255.255.0 ip nat enableip nat source route-map RMAP1 pool POOL1 overloadip nat source ...

Hi, I am trying to understand if the following policy can be applied to a Sub-rate Interface which is the Hub Site. The intent is to create a shaper for each and every remote site so that the hub cannot overrun the remote sites which have smaller cir...

Hi, does anyone know what enhancements, fixes, etc are included in the Cisco 887VA VDSL firmware version A2pv6C035l.d23j, relased 29-MAR-2013.I can't seem to find any release notes with this firmware.We are using version A2pv6C035d.d23j firmware on a...

Hi, i have a 876 Router, connected to the Internet and a VPN. From inside i would like to pass all traffic destinied to 192.168.0.0 255.255.255.0 to the VirtualPPP IF and al the other to the Internet (vlan2) I have created this rule, but after applyi...

Hi,i am trying to set up a vpn that will pass both layer 2 and layer 3 traffic. i have 2 887VA routers and these communicate via adsl lines. They are currently passing layer 3 traffic without any issues and i have used an IPSEC-ISAKMP security.It has...

Good mornign all,I have a Cisco 2911 router which is running the c2900-universallk9-mz.SPA.153-1.T versionOn this router, a GRE without IPSEC tunnel is configured and works fine. For management purposes I have to create an IPSEC tunnel which terminat...

hi all,     i need to know if the built-in GE ports in ASR1001 or ASR 1002 (-X) have the features of QoS without restrictions, or QoS features are supported in SPA modlue ports only?thanks in advance for your support.