Buy or Renew
Buy or Renew

Routing

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

Labels

Forum Posts

Start a conversation

Regarding IOS in 7206

Hi Team,We could not able to upload an IOS for 7206 router with NPE-150 via xmodem as there was no image available in flash it is in rommon mode. But same can be done in 1841. So how to upload an image in flah for 7206 via xmodem.Where the IOS will b...

High Latency on Eigrp

Hi, I have used a ospf as a routing protocol. When using ospf the ping response was 2-3 ms, now I changed the routing protocol to EIGRP, disabling the OSPF. Now the ping response is 20-25 ms. Why the latency grows up, I don't understand. The EIGRP is...

IPSec VPN Backup

                   Hi to all,I have the need to configure a backup VPN, I have remote branches with cisco 800 routers that make a VPN to an ASA5510 in the main offices, but as a DRP I want to have a backup VPN to another site. I dont know if it is a ...

Resolved! Show routing protocol

Hi everyone. I'm going to start a networking subject next week and I'm testing Packet Tracer a little bit. I would like to know how to see the routing protocol in the terminal of a Cisco router, and also if it's Static, RIP or OSPF. Which commands sh...

Router Cisco 1901 suport features

            Router Information:C1905 Router, 2 GE, HWIC-1T, CAB-SS-V35MT, 256F/256D, IPBase  V.35 Cable, DTE Male to Smart Serial, 10 Feet  IP Base License  for Cisco   1900  AC Power Cord (Brazil), C13, NBR 14136, 2.1M  Cisco 1900 IOS UNIVERSAL  Dat...

Resolved! Bad Telco workaround?

Hi,I have a client with the following issue. Their ISP refuses to provide infrastructure (copper pair) with signal to noise ratios that would support even moderate DSL speeds. Ironic too that the switch is only two blocks away. It's in a rural area. ...

lcaruso by • Level 6
  • 1651 Views
  • 7 replies
  • 0 Helpful votes

E1 unframe data configuration

Dear all,If I have two E1 router directly connected each other by using G.703 unframe method for data transimission. How to configure the router? Any sample configuration?   Thanks!               

acbennyma by • Level 1
  • 620 Views
  • 2 replies
  • 0 Helpful votes

Resolved! RIPv2 / routing domain

                   helloi found that there is a field in RIPv2 header that is : routing domain.it seems to be like a process id (like vlan id) so that routers that do not have the same routing domain will not process RIPv2 packets. 1-am i right ?2-ho...

ohassairi by • Level 5
  • 3001 Views
  • 7 replies
  • 0 Helpful votes

Help - 887VA-M basic Config non nat

Hello,I am struggling to get this working afetr spending many hours looking at it I am now completely stuck. We are upgradng from a 857W to this 887 VA-M I have some experience of IOS and the 800 series. Our 857W works perfectly using almost the same...

antonical by • Level 1
  • 699 Views
  • 2 replies
  • 0 Helpful votes

how i can configure local vlan ??

good morning alli have two question what is the difference between local vlan and distributed vlan how i can configure each ( what s the difference in configuration ) what i know is that we configure vlan in the core switch with this commandip dhcp p...

Resolved! Cisco Service-Ready Engine 910

Hi all, can I install and Cisco WAAS and Cisco Prime Network Analysis Module (NAM) together on a single Cisco Service-Ready Engine (SRE) 910 module? Or it can only run 1 of the software?Thanks

VLAN span across Point-to-Point link

We are planning to get a 500 Mbps point to point Ethernet connection  between HQ and DR. Can we just put 2 switches on either side and  configure them as trunk ports and Span the VLANs across the 2 sites? Do  we have to give any special instructions ...

Resolved! ASA QOS Question

New Location. 1.5mbps DSL. A few phones, thin clients, and one desktop.Simple setup : 2960 ------ ASA ----- ISP (DSL) 1.5mbps up/downCouple questions:1. I have theoretically 1500000bits to allot out in this policy map. The desktop,thin clients, and d...

Load more