Routing

Hi,I have a 2921 router, with UCK9 services on it.  I've installed a VWIC2-2MFT but the system is not seeing it.  I've been told there is a command required to enable the card, is this true?  If so, can anyone point me in the right direction with reg...

Hi,I have this route on router:Ip route  x.x.x.x 255.255.255.255  10.12.20.1  track 101 Track 1 >>  a.b.c.d When track 1 is down, X.x.x.x ip address should be y.y.y.y

Hi, Allthanks in Advance,while power off and power com the router went to rmon mode and its shown like thishow to trouble shoot this problemSystem Bootstrap, Version 12.4(11r)XW3, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisco.com/techsupp...

Hi Every body,We have two internet connection,we want to  use both the link simultaneously.One link has PPP encapsulation,so i have created 1 dialer interface.Our problem is that when  we run one connection at a time,every thing works fine,but as we ...

Hi All,attached below is the Design i have in place.what actually in place are static routes and a GRE IPSEC tunnel in place with static routesWe have sites in each town but we have 2 principal towns or sites.But we BGP with our uplink provider  have...

Hi All,Attached below is disgram that show how my BGP session is establish.1. main flow is through my principal provider2. backup will serve when principal is downWill to know the ideal config for this to make it work and with any traffic impact.Wish...

hi,can any one tell me any command that shows this much traffic has entered the priority queue on a router. i have done following configuration and used following portion but i am not able to see packets incrementing if i ping with the source allowed...

Hi all.I looked but could not find any information on what's the use of the USB interface on my 2801 router. I saw something about Cisco USB memory module and eToken by Aladdin. Is this interface restricted to Cisco and Aladdin only? Thanks.

Dear,I have Giga Ethrnet Interface in 3845 CISCO router and I made different sub-interfaces. I have appliaed wccp in the main iterface as well as in sub interfaces. However, I have noticed that wccp worked with some sub-interfaces and not working wit...

Hellosomeone can help me to understand if SFP-GE-T module supports connections ethernet 10/100/100 ?Thanks a lot

I'm trying to found information on how to attach a serial cable to a patch panel. I've searched google without much success. Can anyone help push me in the right direction? Any help would be appreciated.Thanks,Ray