Routing

We have two locations 10 miles apart and need connectivity between them. A local provider can run a 30MB fiber connection between the 2 sites at a very reasonable cost. We would have to provide the routers however. I have worked with Cisco routers be...

Hi,I would like to know what is the maximun throughput of WS-X6148-GE and the real mapping between port to ASIC.At Cisco on http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/hardware/Module_Installation/Mod_Install_Guide/02ethern.html#wp10428...

interface VlanXip address 10.0.0.0 255.255.255.0ip access-group VLANX_block inendOn 65k VSS 1440, I have an inbound ACL blocking\permiting hosts of VLANx to other VLANs.Now there is a requirement that there is a specific host in the VLANX which shoul...

We're installing ASR1000 series (ASR1001 and ASR1006) routers on a new WAN and have a requirement to enrypt the traffic between the EIGRP neighbors.  Each ASR will be connected to the MOE with a gig interface and we will be using L3 on the interfaces...

We have a pretty typical set up for BGP, 2 routers, each connected to a different ISP. There is iBGP running between the internal routers as well on a dedicated interface and HSRP on the inside interface.To control outbound traffic, we have a local p...

This is my first post so I hope I explain the problem suitably and can get someone interested. =)I seem to be having an issue where certain very packets are being dropped/lost by my office router. The reproducible situation is, when I attempt a DNS z...

Hi,I asked many questions about this topic but, I haven't gotten the answers I need to move forward. With the 5505 I want to connect two sets of users to the Internet but, I want to keep the two sets of users seperate. I need to upgrade the license t...

Hi, I have a WAN setup using GRE over IPSec to enable OSPF routing updates. The OSPF is working fine and traffic is flowing across the network through the GRE tunnels, however rather than using CEF to switch the packets through the router it is punti...

I am trying to configure QOS on a Cisco 861 router. The problem we are trying to solve is that when someone downloads a file from the internet it causes the RDP sessions that connect to an offsite server to slow down tremendously. I no very little ab...

Please give me some pros and cons of using BGP AS Over-ride in MPLS environment...regards,Mohsin

Dear alli have a vmware in my datacenter with many vps.i want to know wich solution is better for security in this senario.private vlan or using vrf?is there any compaire between vrf and private vlanthank you

Hi All,In my reviewing for my exam, I came across the following practice question, and I find it a bit ambiguous in sections. I am wondering if someone can help?What does a router do when running distance vector protocols? (ONLY CHOOSE 2):     A: Sen...