Routing

Hi,I have a ME3600X switch and I would like configure a PBR (Policy Based Routing), somebody know how I can make this?Regards,Leandro Oliveira

HiI have a copper over ethernet connected to an adtran 908e connected to an ASA 5505 with a port 192.168.150.254 connected to the router on the Gigabitethernet 0/0I can ping to internal and external ip addresses but when a device is connected through...

Hello everyone!Here is my current setup:1 isp connection which splits into two. One plugs into 5510 with ouside ip and the other plugs into the other 5510 with outside ip address. see diagram below: Router routes are set as: ip route 0.0.0.0 0.0.0.0 ...

We are implementing the network design between the two sites (OLD Data center and NEW Data Center), scheme in attachement.We have chosen this scheme on the following criteria:- A single IP network between the sites (for simplicity migration);- Fault ...

I am trying to find out what the maximum amount of HSRP/Standby groups a Cisco 3945 will support.I found this link that I think says 256 http://www.cisco.com/en/US/customer/tech/tk648/tk362/technologies_q_and_a_item09186a00800a9679.shtml#q5Can anyone...

Hi ,We have a 3845  router deployed at a tier  2 ISP  for  PATing user based sessions to the Internet ,the issue happening is when the NAT table size reaches approximately 2,000,000 the router gets hung and has to be restarted  the router has a memor...

Hi every oneI've been using my 2509 router as an access server for my 3 routers, 1 frame-relay (3640) and 4 switches for the past 2 months and it work great till this morning. As soon as the async lights on when i try to connect, it just hangs.  It d...

We have a ciso 2800 router with a vpn over a WAN to a Checkpoint firewall The WAN is 300M and has a 30ms delayThe vpn was moved over there from a WAN with on ly 2M BW but less delay.But now the performance is worse.ive read some about teh use of tcp-...

Hi, can anyone tell me if it is possible to inject the default route into OSPF but only allow it out certain interfaces. For example I want to send it out a couple of tunnels but nowhere else. I assume if it is possible it would be by using a route-m...

Ok,So having some issues with routing on a ASA.  Not sure if the ASA can do what we are trying to do with it however it was the equipment we have on hand and was asked to attempt to make it work.Below is the config of the ASA.  The problem I am havin...

Hi friends,I have a problem with the command mls qos trust dscp, I used the ios c2800nm-ipvoice_ivs-mz.124-25f.bin but i can not enable dont show me the complete command in the interface Ethernet o Giga. examplerouter(config-if)#mls ?I want to config...

We have 3 WAN interfaces - a T1 for the public queries to our web and mail servers, and two cable connections for outbound web traffic. There are technically better solutions, but these were purchased for cost saving reasons, and I have to get it to ...

We are implementing a MPLS network between our corporate office and our two data centers.  The basic network diagram is shown.  We will be using Cisco 2900 series routers.  The provider requires static or BGP.  What is recommended, static or BGP, and...